Freezers - Page 4 - Recent Questions, Troubleshooting & Support
Woods Freezer. Where is the off position on it please?
Question edited for clarity.
Question moved from Cars and Trucks category.
Freezers don't have controls INSIDE the freezer, as it is too cold for efficient operation. Chest freezers have them on the outside behind the grille where the compressor is. Upright freezers usually has electronic controls on the door. You give o clue as to what type you have or what model you have. You can easily turn it off by removing the wall plug!
Or you can find the manual. 'Off' on a thermostat is normally fully clockwise.
https://www.google.com/search?q=woods+freezer+manual
..
I’m trying to get hold of a manual for a KYOTO (IcelandLtd) Delux KU72 upright freezer. Help would be appreciated...
Unfortunately, I was unable to find a direct link to a manual for the KYOTO (Iceland Ltd) Delux KU72 upright freezer. However, there are a few options that you can try:
- Contact the manufacturer: You can try contacting KYOTO (Iceland Ltd) directly and requesting a copy of the manual. You can find their contact information on their website or through a quick online search.
- Search online: You can try searching online for a manual using the model number or product name. Sometimes, other users may have uploaded a copy of the manual online or posted a link to it on a forum.
- Check for similar models: If you are unable to find the manual for the exact model, you can try looking for a manual for a similar model made by the same manufacturer. The manual for a similar model may contain similar instructions and specifications that can be helpful.
I hope these suggestions help you find the manual you are looking for.
2/26/2023 12:11:34 PM •
Freezers
•
Answered
on Feb 26, 2023
Flex ice Machin 404a gas ..how much suction and discharge pressure should be..?
The ideal suction and discharge pressures for a Flex Ice Machine using 404a refrigerant can vary depending on several factors, including the ambient temperature and the load on the machine. However, here are some general guidelines:
Suction pressure: The suction pressure should typically be in the range of 30-45 psi (pounds per square inch) for a 404a refrigerant system. This pressure corresponds to a saturation temperature of around 20-30°F (-6.7 to -1.1°C).
Discharge pressure: The discharge pressure should typically be in the range of 225-250 psi. This pressure corresponds to a saturation temperature of around 100-110°F (37.8 to 43.3°C).
It's important to note that these are general guidelines, and the ideal pressures can vary based on the specific conditions of the system. It's also important to ensure that the pressures are within the manufacturer's recommended range, as pressures that are too high or too low can indicate a problem with the system. If you are experiencing issues with your Flex Ice Machine, it's recommended to consult a qualified technician for assistance.
2/24/2023 8:59:30 AM •
Freezers
•
Answered
on Feb 24, 2023
Can i leave igloo ice machine when it is full
Yes, it is safe to leave an Igloo ice machine when it is full. However, if you plan to leave the ice in the machine for an extended period, it is recommended to transfer the ice to a freezer to prevent melting and refreezing, which can cause the ice to clump together.
2/14/2023 12:11:25 PM •
Freezers
•
Answered
on Feb 14, 2023
My frgidaire chest freezer model # MFC07M3FW2 will not come on after short move. Plugged back in and light will not even come on
If your Frigidaire chest freezer is not turning on after a short move and the light is not even coming on, there may be a few things that could be causing this issue:
- Check the power source: Make sure that the freezer is properly plugged in and the outlet is receiving power. You can try plugging another device into the same outlet to confirm if it's working or not.
- Check the power cord: Check to see if the power cord is damaged or frayed. If it is, it may need to be replaced.
- Check the control board: There may be an issue with the control board of the freezer. Try unplugging the freezer for a few minutes and then plugging it back in. This can sometimes reset the control board.
- Check the compressor: If the compressor is not functioning properly, the freezer will not cool. You may need to contact a professional to repair or replace the compressor.
If none of these solutions work, it may be best to contact a professional to diagnose and fix the issue.
2/14/2023 12:09:38 PM •
Freezers
•
Answered
on Feb 14, 2023
My igloo model frw062 stoped cooling
If your igloo model frw062 has stopped cooling, there are a few possible reasons why this might be happening:
- The temperature control could be malfunctioning: If the temperature control is not working properly, it could be causing the refrigerator to run continuously and not cool properly.
- The condenser coils could be dirty: Over time, the condenser coils can become dirty, which can cause them to overheat and reduce the cooling efficiency of the refrigerator.
- The compressor could be failing: The compressor is responsible for compressing the refrigerant and pumping it through the system. If the compressor is failing, it may not be able to do its job effectively, which could result in poor cooling performance.
- The refrigerant could be leaking: If the refrigerant is leaking from the system, the refrigerator will not be able to cool properly.
To fix the issue, you may need to troubleshoot the refrigerator and try to determine the cause of the problem. If you are unable to identify the issue, it may be best to contact a professional for assistance.
2/14/2023 12:08:28 PM •
Freezers
•
Answered
on Feb 14, 2023
Red light flashing on tall freezer, temp down to -6
A flashing red light on a tall freezer indicates that the appliance has detected a temperature alarm, and the temperature inside the freezer has likely dropped below the desired range. A temperature of -6 degrees Celsius is much lower than the recommended temperature for a freezer (-18 degrees Celsius), which can cause frozen food to become damaged or spoiled.
To resolve the issue, you should first check the freezer's manual for troubleshooting tips and recommended actions. In general, you may need to adjust the thermostat to a higher temperature, remove any obstructions to airflow, or defrost the freezer if ice buildup is blocking the evaporator coils. If the issue persists, you should contact a qualified technician to diagnose and repair the freezer.
2/14/2023 12:06:30 PM •
Freezers
•
Answered
on Feb 14, 2023
When should you use SUPER byutton on Skandiluxe chest freezer
The SUPER button on a Skandiluxe chest freezer is typically used when you need to freeze food quickly, such as when you've just added a large amount of unfrozen food to the freezer. The SUPER function causes the freezer to operate at its coldest temperature for a period of time, which helps to freeze the food more quickly. After the desired amount of time, you can turn off the SUPER function to return the freezer to its normal operating mode.
2/14/2023 8:26:17 AM •
Freezers
•
Answered
on Feb 14, 2023
Loud noise when I turn on my 102c igloo portable ice maker
A loud noise when turning on an Igloo portable ice maker could indicate a problem with the compressor or a malfunctioning fan. It is recommended to unplug the appliance and have it inspected and repaired by a qualified technician.
2/14/2023 8:24:59 AM •
Freezers
•
Answered
on Feb 14, 2023
For Westinghouse fj383 freezer where is the defrost timer located
The defrost timer in a Westinghouse fj383 freezer is typically located at the back of the unit, near the compressor. It may be behind a cover or housing that needs to be removed in order to access the timer. If you're unsure about locating the defrost timer or don't feel comfortable working on your freezer, it's best to consult the user manual or contact a professional technician for assistance.
2/14/2023 8:24:10 AM •
Freezers
•
Answered
on Feb 14, 2023
Where is the 9V battery located on a Kenmore upright freezer model 970
The location of the 9V battery on a Kenmore upright freezer model 970 can vary depending on the specific model and design. However, in general, the 9V battery is typically located in the control panel or on the back of the freezer near the compressor. You may need to consult the freezer's manual or contact Kenmore customer support for more specific information regarding your model.
Hoshizaki F-450maf has no water in reservoir tank
If the Hoshizaki F-450maf ice machine's reservoir tank has no water, you should first check that the machine is properly connected to a water supply and that the water supply valve is turned on. You should also check that the machine's water filter is clean and not clogged. Additionally, make sure that the float switch is functioning properly and that it is not stuck in the "off" position. If these steps do not resolve the issue, you may need to consult the machine's manual or contact a professional for further assistance.
2/14/2023 8:15:39 AM •
Hoshizaki...
•
Answered
on Feb 14, 2023
Not finding what you are looking for?