Bosch Refrigerators - Page 3 - Recent Questions, Troubleshooting & Support

If the retaining screws aren't obvious they are either hidden behind trim inserts or (rather unlikely) they are inside the door, or lid if a chest freezer. Computers, robots and laser cutting tools have allowed manufacturers to realise ambitions to perfectly fitting trim pieces that can need a strong light and magnification to find the gap.

Call repairmen

Measure the continuity of the heating element. Make sure the timer motor isn't bound up with ice. Either of these components can cause the ice to not release

SEE PICS HOPE IT HELPS MOST ARE SIMIALIR

if you pop the caps off the top and bottom you can readjust the door by loosening and retightening the screws after u set the door adjustment

How do you adjust the temperature on this panel?

Hi,
This is most likely a blocked drain pipe - blocked with ice that is.

Remove all the drawers in the freezer - and stack them up.
With the unit switched off and unplugged, undo the fixings on the rear pannel in the freezer (behind the drawers)
Remove it to see the evaporator coils etc.
At the base there should be a channel - and a hole leading to the drain pipe. This needs unblocking wih a thin flexible cable. -net curtain support wire is ideal, and cheap. or use a short length of insulated cable.
Check it comes out at the rear of the unit onto the evaporator container - situated on top ofthe compressor.
Replace everything and switch on.

The diverter valve usually has a coil on it to open or close it. The valve may be sticking. ??

If so, I suggest turning off the fridge and let it defrost.

Typically that'd be where they are..you should see the openings in the back of the freezer and the fridge...barring any obstructions sounds like a computer board issue

wish I could help but you are correct entire top compartment has to be removed

Here is a possible fix I used on a different brand. Unplug your fridge and let it completely thaw. Sometimes drains and controls get frozen from condensation and auto defrost drains also freeze up. Make sure you have some towels to soak up any possible flooding as the catch tray may overflow. Your food should be put into cooler to stop it from thawing. This will take 5 - 6 hours. Good luck!

You can find most user manauls at, www.managemyhome.com, on the right side of the page. You will need the model number off the product information label affixed to the unit.

Does the thermostat kick in when adjusted?

its a relay

Probably air in water line

Check and or clean the diverter flap in the back of the refrigerator make sure all vents inside are clear and not blocked ,If this does not fix the problem It could be the servo motor for the diverter

you should always provide your model number with your questions here helps us determine what you have but knowing that you have this brand of refrigerator also means that you probably are going to have to talk to the factory they are the only ones that provide the parts for that that refrigerator at this point I think you have a bad electrical connection in the door or either the door switch

Press the lock again to unlock. If the second padlock is on, press and hold for 3 seconds to unlock the child lock.