My magic chef stove model#31100paw oven will not heat up but all four stove burners are working just fin.what is going on?

Possible locations shown in article at the web link below:

https://www.hunker.com/13409112/how-to-find-a-model-number-on-a-magic-chef-oven


How to Find Model Number on Magic Chef Oven Hunker


Quoting the link above:

Step 1 Open the oven door. At the top, left-hand corner of the open oven, locate the model number tag.
Step 2 Check under the burners. Lift each burner on the stove off to see if the plate is underneath. Do this if the plate is not located on the inside of the oven.

hope this helps a little...
https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Range-Stove-Oven/15-104--/Magic-Chef-Stove-burner-won-t-light

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101

Can you light the burners ok with a match, if so you might need a spark module Whatever you do don't raise the top. Check out this video HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Replaced the ignitor.

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101


wwt

You probably have a 1940's model of Magic Chef. Check for the model number under the lid of the cook top on the upper right hand side of the stove. It should have the model number and the serial number, too. You will need both. The Old Applicance Club run by Jack Santoro is the place to go along with a site called "Antique gas stoves"in Georgia. Good luck with the world of vintage stoves.

look at the burners in the oven,they usually go bad where they hook to the unit,it will look like a peice is missing.if this is not the case, a wire is loose in your breaker and you're running on 110 instead of 220

Yes this is normal. you can use that burner to keep things warm without turning it on, saves energy.