20 Most Recent Jenn-Air JDR8895AAS Dual Fuel (Electric and Gas) Kitchen Range - Page 6 Questions & Answers

You will need a conversion kit from natural to LP gas.

Take a look here for price range.

Kit

Here is another good place to look

Hope you can find a cheap one

the only thing which I found is after I clean the burners, maybe some dirt in.

hi there sounds like a faulty door interlock!!!!
have you tried just leaving the cooker on self clean as some models will lock them selfs.

Is a gas unit ?

go to jenn air web site -find your stove model number and find user & care guide that should help you

We decided to go with a different stove. Thanks anyway!

if it is cooled enough then try this
hold back and enter hold for three seconds , unlocking door will appear in display when control and door are unlocking
good luck

if this is a new stove need to change the pin in the regulator ,
then need to replace the stove top orifices from gas to l.p.
check under the stove for pieces they tape them under there by the regulator -- that how i found mine under my new jenn air
check the stove companies web site for a users manual also

self cleaning uses above normal cooking temps
check how many amps your stove is rated for -40 amps ?
see what size breaker you have 30amp ?
call electrician
hope this helps

there is dirt between the ignitor and the burner or the ignitor is to close to the burner

hi your ignitors wont last long, they are similar to a fuse, you should be able to change the ignitor and if it still does not ignite look to see the space of the ignitor and try shorten it.

here is a link for your owners manual click here

To set Self-Clean:
1. Close the oven door.
2. Press the appropriate Clean pad.
• CLEAN flashes.
• SET and UPPER or LOWER flash in the display.
3. Press the Autoset pad.
• “MEd” (Medium Soil, 3 hours) is displayed.
4. Press the Autoset pad to scroll through the self-cleaning
settings.
“HVy” (Heavy Soil, 4 hours)
“MEd” (Medium soil, 3 hours)
“LITE” ( Light Soil, 2 hours)
Choosing the soil level of the oven automatically programs
the self-cleaning time.
5. After four seconds, the oven will start cleaning.
• If the door is not closed, beeps will sound and ‘door’ will
display. If the door is not closed within 30 seconds, the
self-cleaning operation will be canceled and the display
will return to the time of day.
• CLEAN will appear in the display.
• LOCK will flash in the display. Once the door locks,
LOCK will remain steady.
• The cleaning time will start counting down in the
display.

Please take the time to rate this solution

There may be, but your problem is not any of those. You apparently have a short to ground somewhere that need's to be located and repaired.

Remove the burner caps (where the gas and flame come out) and wash in warm soapy water, using a plastic toothbrush like brush to scrub thoroughly.

Also clean/scrub the burner bases and ignition knob on the top of the cooktop.

When you reassemble, make sure the burner caps are properly seated in the burner bases.

Sounds like one of the four switches attached to the burner control knob may have failed where the switch does not fully open. This could be due to moisture or grease having seeped into the burner control/switch.

You can find a wiring diagram for this unit at www.SearsPartsDirect.com by typing in your model number.

Reply back if you would like further help.

Try shutting off the main breaker for a minute or so and then turn it back on and set the clock. It worked for me. I've had to repeat it the next time I self clean though.

I had the same issue with washing the top with water and cleaning solution. I had arching, eventually one burner failed to ignite. I tried the above solution and it did not work. Remove the ceramic top on the burner that will not ignite. Turn on another working element. Do you see the igniter working?

If so slowly turn on the gas on the failed burner and it will ignite. I'm looking into what component automatically controls the igniting and gas release when the knob is turned on.

Does your stove have an electric self-cleaning cycle?

If so, do it. I was surprised how well it worked on the glass too!

Remember though it may take 3-4 hours at a very high temperature.