Jenn-Air JDR8895AAS Dual Fuel (Electric and Gas) Kitchen Range "fuse replacement line" Questions

no fuse,all parts is direct line to the power but its hard to explain how to check the unit if is ok or not if you are no basic idea how to do in the 1st place,call and service technician to make sure

...fuse located? Check your incoming power for 240 volts and your circuit breaker. Check the cord where it attaches to the back of the range. If they are OK,look for a loose or broken wire. There are no ...

...line," it typically indicates an issue with the electrical power supply. Here are a few troubleshooting steps you can try to resolve the problem: Check the Power Supply: Ensure that the stove is ...

...replacement of the control is required. F1-E1 Defective ERC Replace ERC F2-E0 Shorted Keypad Replace Keypad F3-E0 Sensor or Sensor Fuse Open Replace Sensor or Fuse F3-E1 Shorted wire or Sensor locate ...

Two of the top range elements do not work after one of them blew out and was replaced. Is there a fuse blown out,too. Where is it located? the lines in the stove are fuseable link so when one goes ...

...bad. You may have also possibly blown a fuse which would require removing the back panel. Most middle of the line ovens do not have any type of fuse wired between the control board and

...line and connection to your oven, is that something is faulty with the electric igniter for the oven. First check the fuse box or circuit breaker panel of your home the fuse for the oven connection ...

...fuse melted and is just replaced. The cause of the excessive heat needs to be determined. I had the same problem with a KitchenAid double oven. There was a factory recall on the unit which required ...

...Fuse is no good. Question 1: Where can I get a replacement, and should it be ok to just replace the in-line fuse (it has thin wires protruding from each end, which were crimped to the heavier ...

...fuse that comes off the main line or a problem with the thermostat? How can you get at the fuse without destroying the whole thing (it's shrink wrapped) or do you need to cut the cover, test/replace ...