20 Most Recent Cellular Innovations HFBLU-CX1 Wireless Headset - Page 13 Questions & Answers

HI.... yes ....it is possible to program them in DMO, this is done in the RSS,.... so I am advised directly from inside Motorola .... but a copy of the RSS is just not available.... ... if fact Motorola seems to officially deny the D700 ever existed ... good luck in finding a solution.

Hello there! Assuming your talking about "XtremeMan SOMA BT" I'm not a fan of assumptions but... if this is the device your are referring to then here you go below. If this is not the device you are making reference to, then please respond with the model number and make/brand of the device. Thanks for your visit and good luck. 1. With the unit on or off, plug the included cable from the USB jack on your computer to the micro USB jack v on this unit. While charging, the battery level will be shown by the LED indicators with the current level LED blinking. When all the LED indicators light solid, then the unit is fully charged. 2. If the power level is less than 10%, the left-most LED indicator will start blinking, which means that the Soma BT needs to be charged. Using the Soma BT with a Bluetooth Device 1. Turn on the unit as shown above. 2. Press and hold the Bluetooth button U for approximately three seconds until a beep sounds and the right-most LED starts blinking. 3. Within five minutes, select Soma BT from the Bluetooth List on the external device. See external device's owner's manual for details. When paired successfully, the Soma BT will beep twice and the right-most LED will light https://www.manualslib.com/manual/1540329/Xtrememac-Soma-Bt.html?page=8#manual Check Here

The meter is out of range! Move the meter closer to the main box.

No one answered the question.

cut bluetooth on phone.. unplug alexa and tell her to turn of blue tooth on devices.

T squelch and PTT on can be reset by button presses. It's shown in the manual, available for free online in various places.

See attached link

• There is no need to send the radio to some unsanctioned moonlighter.
• I normally don't recommend clipping parts but for this radio there is not much else to do and it looks OK on an Oscilloscope too. Clip diode 205 to increase modulation. Then take a plastic flat tool and spread L 203 coils apart about a 1/8" each, nice and even and make sure they don't touch any metal.

• Hope this helps.

Unfortunately these mics are not professional quality and they tend to be less accurate. The variable selectors have a wide tolerance and are not precise, thus; they tend to be hard to control. Not much you can do...so use it as is, or get a new unit.

Follow the directions on the link below to see if you can pair the headset with your PS4. Bluetooth Devices

Look here: http://www.thedefpom.com/ If this doesn't have your answer, call Ranger. Good luck.

https://forums.radioreference.com/threads/pro-106-scanner-help-scanner-stuck-on-one-channel.245676/ https://smallbusiness.chron.com/can-scanner-seems-stuck-61253.html

aTOK. that error means the firmware is scrambled. CS = check SUM of the EEPROM firmware failed, or, OMG a low battery, there are 6 choices of recharable batteries, but they can go bad, just like all batteries do often charge it for 24 hours yet,??>???? it is a walkie talk transceiver, radio. hand held.. not just a radio

guessing here but check the left/right balance pot is working properly and that the left side is not disconnected if no one else answer , it will be off to a repair shop for a proper diagnosis and quote

If you're referring to the 200bt portable speaker set, this isnt possible. Car stereos are only designed for input over bluetooth not output. Now if it really important to you, you can use a line level adapter to tap into the rear speakers of your vehicle, take that output and plug it into your speakers with an aux cord, or if you have an after market radio you can use RCA cables and a jack adapter to do the same. If you must bluetooth (eg. out of vehicle operation of speakers) buy a cheap bluetooth output adapter (shark makes one) use a small cigarette lighter inverter to power it, and then you can plug your aux jack into it and bluetooth to a speaker set outside of the car. If you use this in conjunction with the speakers car there will be a delay between those speakers and your bluetooth speakers.

You likely tripped a fuse or circuit breaker. If you are referring to an automotive type stereo there will be 2 fuses associated with this problem. One is directly on the back of the head unit and is usually 10amp, the other is in your vehicle fuse box usually labeled radio in the diagram.

I am guessing the CB has a fault and needs taking to a CB Doctor...

try putting in your make an model then search google for (your item+mk+model+pinout?) like this. *shruggs* mite get lucky

I do not know about these items but if it works on other phones then a few things spring to mind, that moto might use a different version of plug like a "3 ring + tip" plus there maybe one with 4 + tip. Another thought is the mic needs power if its an electret type which that moto does not supply. The connection of those earbuds may be wired a little different to how moto needs, many manufacturers do this so you buy their bits and bobs. Lastly the moto may need some feature selection in its menu system to be turned on so look through its settings for audio-microphone etc. Hope this might help

You might be lucky but I would doubt it, to me its another Chinese funny, things made for certain companies or supplied to companies who are the sole or limited suppliers. I noticed on the rear of the instruction manual it only gave a short labour warranty and had its company location, most of these type purchases require return to the place that sold it or they will give a service agent to send it to. I have found that with these items parts and manuals are not around so if you are going to fix it yourself you would have to wing it, as they can be made with a variety of parts not the same set as time passes. Hope this helps in some way.........