...car to heat up. Hello my name is Ben. You will be fine just reconnecting the transmission lines. No need to bleed them. Just be sure to check your transmission fluid and keep it at the proper
...bleed valve located at the 12 o'clock position, between tabs on seal. Install thermostat and seal into thermostat housing . If removed, install two studs. Install thermostat, thermostat housing and ...
Question about Chrysler Concorde
...proper levels. Bleed air from the coolant system:This is best done by running the engine with the radiator cap off until you see when the air bubbles stop coming up. Check the radiator fans: The ...
...proper levels. Bleed air from the coolant system:This is best done by running the engine with the radiator cap off until you see when the air bubbles stop coming up. Check the radiator fans: The ...
Question about Lincoln Cars & Trucks
...bleed it properly ? check your vacuum actuated heater valve assembly under the hood for proper function .possible malfunctioning thermostat Bleeding nipple is located on thermostat hosing. Stop the ...
Question about Chrysler Concorde
...bleed the system properly. Even after the proper bleeding procedure is followed, some air bubbles may remain in the heater lines, preventing coolant from circulating properly. I have had some luck ...
...coolant starts to flow out of the bleed valve, if theres no bleed valve take the top radiator hose off of the engine side and allow the cooling system to purge the air out through the top of the ...
...bleed the coolant system after replacing this part? The water outlet housing if installed properly, shouldn't leak. The only way to build up too much pressure would be for the thermostat to be stuck ...
...proper procedure for bleed the cooling system Allow the vehicle to run with the rad cap off adding coolant as necessary until the upper and lower rad hoses are hot indicating the thermostat is open. ...
Question about Chrysler Concorde
...The coolant level should go down, this is normal as the system bleeds the air pockets out of the system. Refill the system with coolant to the proper level. Turn the engine OFF and check for
658 questions posted
Usually answered in minutes!
405 Questions
313 Questions
291 Questions
285 Questions
268 Questions