HP LaserJet 1300 Printer "printing half lines" Questions

...Half take printing from HP 1020 printer. If I give Print command only two or three line print come on paper after that four to five line black again two or three line print with half image. Try ...

...half printed page: if seems OK, then you have problem on fusing unit, probably damaged fuser film. If gray lines are present here and the green cylinder also is dirty, your cartridge must be changed. ...

...half of the page would be little lines and garbles stuff. If I split this same page in half, then it will print just fine. It seems sort of like a memory problem, but I have never had this problem ...

...jet 1300 the print output is always has overlapping figures or lines.around half a page later a faded print of the same page is printed this printer prints a multipage document on 1 page ...

...Lines down the page can be caused by a few different things. The most common are the toner cartridge having a defect, or the fuser being worn out. The quickest way to figure out which one is to do a ...

lines. Run a half test. Start printing a few pages, as it prints open the cover, remove the toner and look down at the paper. Does it have lines on the right side? If yes - replace the toner cartridge

half is just applied to the paper, if you see the black lines on the fused side of the page its the fuser if you see it on the entire page it could be the etb or the cartridge. possible fix: This is a

...half page stop the printing by open the door remove the toner and look the paper if you see the line the problem is from toner replace toner cartidge if you see the image ok means the problem begins ...

...1and half inch line comes in print . after printing 10* or 50 pages* at a time then you should off your printer for 15 minutes then restart it again.*problems comes because your printer goes very ...

half print test page (open the cover in the middle of the printing process). Inspect if the line is appearing before the fusing unit or after it. Try printing with different cartridge, just to be sure