2001 Land Rover Discovery Series II Logo
Posted on Aug 24, 2017

My remote fob stop communicating with my car (LR DISCOVERY 2003 TD5) i end up having to unlock the door with the key an the alarm went of tried to start the car and it started but only for a few seconds and then die. Replace the remote battery with a new one but that didn't help. i can not disarm the alarm with the remote control. Could you help me figuring this out? thanks Juan

4 Related Answers

Anonymous

  • 275 Answers
  • Posted on Feb 13, 2009

SOURCE: alarm immobillizer

The alarm systems on land rovers are quite tempramental. They work on radio frequencies. If you park next to a radio antenna like they have at post/ telecommunications offices. Then the radio waves they send out can interfere with your cars system, making it think it has been attempted to be broken into, and so immobilises. You should have a 4 digit code called the EKA code. You must have this to knock off the immobilser to start the car. The car must be locked completely, all windows shut and then enter the EKA code using your key.
Hope this helps

Ad

Anonymous

  • 149 Answers
  • Posted on Feb 24, 2010

SOURCE: how to adjust rocker shaft on discovery td5

There are adjustment screws on the rockets according to RAVE.
The procedure is as follows:
1) Rotate the engine clockwise until No 1 injector lobe is at full lift.
2) Rotate rocker adjusting screw clockwise until the injector plunger is felt to bottom out.
3) Rotate rocket adjusting screw anti-clockwise one complete turn to give plunger the required bump clearance and tighten rocker arm adjusting screw locknut to 16Nm. Ensure the screw does not turn as the locknut is tightened.
4) Carry out the procedure for the remaining 4 rocker arms.
5) After completion of rocker arm adjustment slowly rotate engine clockwise 2 complete turns by hand to ensure that no injectors are bottoming out on their plungers.

Anonymous

  • 1 Answer
  • Posted on Jun 09, 2010

SOURCE: Land Rover Discovery TD5 1999. Where is the Fuel Relay Switch

In the engine fuse box under the bonnet ,relay is the closest one to the front of the vehicle ,about £7 to replkace

john thorp

  • 21 Answers
  • Posted on Dec 10, 2010

SOURCE: on my land rover discovery

lock the jeep. hold in unlock position for 5 seconds, you will hear a beep, enter your unique code in a card in the front of the owners manual, will be something like this.
unlock 4 times
lock 8 times
unlock 13 times
lock 3 times
unlock and hopefully you hear 2 bleeps, now wait ten minutes for the alarm to turn off, the red light on the dash will blink really fast and the hazards may go off once, now you have 30 seconds to get your key in the ignition and start the car. but you need the code, apparently land rover will get it for you but you need indentity and proof of ownership etc.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Mustang alarm

Ford sold a Ford branded alarm through the parts department. These sometimes were a dealer installed option on new cars. Mine would randomly stop responding to the remote and I would have the same symptoms as you describe. I had it removed and the original equipment factory system still worked. Be warned, if you have the Ford "accessory" alarm, your key fobs (remotes) are different and the method to program them is different from what you will read online. You can tell if you have the system by looking at your key fob. The standard Mustang key fob is a 4 button (lock, unlock, panic, and trunk). The accessory alarm uses a 3 button remote and clicking unlock twice would pop the trunk. I really wish I had a picture of the remote because there are 3 button Ford key fobs for cars without a trunk release although I don't think you should have one on a Mustang. Long story short, if you have the accessory alarm, you can solve your problem by having it removed but you will need new 4 button key fobs to remotely lock/unlock your doors
0helpful
1answer

2003 malibu alarm won't stop

Well when you replaced the battery did anything else on the key fob work? Often times you have to reprogram the remote in order for it to function properly. Try getting inside the vehicle and manually lock all doors with the driver's side switch. Put the master key in the ignition switch and turn the switch to the run position but do not start it. Now push and hold the lock and unlock buttons at the same time until the locks make noise....may take 10 to 30 seconds. After you have the key fob programmed, see if the alarm will turn off with the remote. Did it work? The only way to totally turn off the alarm is with a GM Tech @ or 3 scan tool and go into body control bidirectional controlling procedures or with a very good aftermarket scanner with good bi-directional functionality.
The alarm works via the body control module on this vehicle and i am thinking it uses the PK2 system and if you do not have a properly coded key or the BCM is loosing memory, then check for any and every blown fuse and replace as needed.to start with.. If the vehicle stays running after starting then the bcm/key is reading correctly.
0helpful
2answers

2003 Montero Sport Remote (FOB)

HI Kemp you might have too reprogram your key fob
check your owner Manuel for how to program key
0helpful
1answer

The battery for my honda civic type - r went flat and when i put a new one in the alarm went off so i tryed to sync the keys to the car ( it tuns the alarm off and u can drive it but once u lock the doors...

Here are the options for disarming a factory alarm while it's going off:

1. Close all doors, trunk and hood. Alarm will stop after preset time.

2. Hit the unlock or lock button on the remote. (One of the 2 works... I just don't remember which.)

3. With all doors, trunk and hood close, insert the key in the driver's door and unlock/lock the doors manually.

Also, is it a factory security system? Is it a honda key fob? or a remote start system perhaps?
0helpful
2answers

2003 Monte Carlo SS, FOBS won't unlock doors (new batterries), use key and open the door with the door open FOB will lock and unlock the door, shut the door and the FOB won't lock the doors. After...

If the passkey is messed up, there will be a light on the dash that says security, or have a picture of a car with a lock thru it. If there is no light when the key is turned forward, then its NOT a passkey problem.



tayjoejoe_35.jpgtayjoejoe_36.jpg
1helpful
1answer

On my land rover discovery td5 [2000] how can i turn the alarm off & start it when the key fob stop's working

lock the jeep. hold in unlock position for 5 seconds, you will hear a beep, enter your unique code in a card in the front of the owners manual, will be something like this.
unlock 4 times
lock 8 times
unlock 13 times
lock 3 times
unlock and hopefully you hear 2 bleeps, now wait ten minutes for the alarm to turn off, the red light on the dash will blink really fast and the hazards may go off once, now you have 30 seconds to get your key in the ignition and start the car. but you need the code, apparently land rover will get it for you but you need indentity and proof of ownership etc.
1helpful
1answer

1995 LR Disco 1 - Te drivers door requires ALLOT

Try spraying into the latch with a lubricant like WD-40. Also spray a little into the key hole itself. Don't be shy when you do the latch and move the nozzle around to reach different areas in the latch. Hope this helps.
Not finding what you are looking for?

98 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...