Ignitin switch will not move with key How do you you replace.... remove the old one

fuse or newtran safety switch

*Turn over. No start.>> Check spark and fuel.
*After remove the key but car still crank. (turn over)
The ignitin switch is stuck>>Check and replace. or ignition wire could be burn that keep touching metal frame.

Good luck

Mai

Check to be sure your shift lever is all the way in the Park position. Move it up and down several times to be sure. If that doesn't work shift into neutral then move steering wheel side-to-side to be sure it isn't locked under tension. Place shifter back into Park position. If that doesn't work check all your fuses. There is a small safety switch located under the shifter boot. It is there to prevent the car from starting when not in Park. A blown fuse can cause it to stop working. If all else fails, remove boot and manually press this switch. If key comes out then that's your problem. Good luck.

Obviously no power to distributor or pump when key is turned on, check ignitin circuit and fuses related to pump and distributor

maybe ignitin switch "key on Igntion" switch

The ignition key cannot be removed from the ignition switch, unless the shift lever is in Park. When the shift lever is in any position other than Park, a solenoid is activated, making it impossible for the key to be removed, until the shift lever is moved to Park.

The kill switch would not stop the key from tirning you may nee to try your backup keys or replace the ignitin cylinder..........

Hi: Have run into same type of problem, turned out to be a dead or very battery. Has nothing to do with the ignitin switch. With a low battery have also had trouble getting the key out of a 95 Jimmy. Boost unit to get running then discommect battery, if unit stall right away replace alternator, if stays running replace battery. If you get the unit runnimg and try to drive it as is you should find lacks power and wants to stall.

use a cordless drill to drill the lock cylinder out.a 3/8 bit will provide enough clearance to remove the lock assembly.