HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.
2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16
Check this info...
Hoep helps (remember rated this).
Also, HERE can find other details: Chrysler-Sebring-Tires
×
SOURCE: Why does 2001 Chrysler sebring A/C cuts in and
this is caused by the sytem being low on charge of refridgerant due to leakage
SOURCE: Why does 2001 Chrysler sebring A/C cuts in and
It's low on refrigerant ( probably uses R-134a) available at WalMart. Low refrigerant pressure switch deactivates A/C compressor for safety reasons.
SOURCE: need the crankshaft main bearing torque specs and
Hello tlittle3: My name is Roger and I will help you.See the attached image. Be sure to follow steps as it is very inportant. You will notice that you need to index some of the bolts. That is merely turning the bolt a specified degree. The crankshaft tie bolts are the bolts that are in the side of the block. install horizontal. Shold you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger
Testimonial: "thanks that what i needed"
SOURCE: Crank shaft bolt torque specs for 2001 chrysler
the dampner is the crank bolt
Testimonial: "This expert is amazing, smart and extremly helpful."
SOURCE: WHAT ARE THE TORQUE SPECS FOR THE INTAKE MANIFOLD
Sorry first attempt got sent by accident
Upper intake manifold bolts/nuts 168 in-lbs
Lower intake manifold nuts are done in 4 steps
Step1. Front nuts 61 in-lbs
Step2. Rear nuts 185 in-lbs
Step3. Front nuts 185 in-lbs
Step4. Repeat Steps 2 and 3
1,175 views
Usually answered in minutes!
×