Check the wiring going to light,wiring running along trunk hinge sometimes breaks, also check all fuses,the third brake light most times is on another fuse circuit,
It could be the Third Brake Light assembly is bad, remove the assembly and have someone step on the brake and you can check to see if you are getting current to the contacts or wires.
If no power, replace the assembly.
SOURCE: How do I replace the
High-Mount Brake Light
NOTE: Depending upon the vehicle, the center high-mount brake light may be accessed from outside the vehicle, through the trunk, or through the passenger compartment.
I'll post the pics here in a sec.
Please don't forget to rate!!!!
SOURCE: 1999 brake light do not work
the problem is the lamp failure indicator module locaten on the left kick pannel right against the fuse box i had the same problem with mine
SOURCE: how can i replace the bulb for the center brake
The lense should unscrew from the outside , some bulbs are push and turn and some are wedge base which just pull out.
push and turn bulbs have a metal base but the wedge base are all glass.
I changed a high stop bulb on a 2001 odyssey in this manner.
SOURCE: HOW DO I REPLACE CENTER BRAKE LIGHT BULB
this is not a bulb u must replace the entire LED fixture, to do this remove the inside trim at rear around rear hatch opening, then you will need to drop the headliner down to access the retainers that hold the third brake fixture in, very easy job.
SOURCE: Brake light, reverse light and turn signal issues
Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.
360 views
Usually answered in minutes!
×