SOURCE: where is the body control module located on a 1997 town & country
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
SOURCE: where is the starter located on the 2004 chrysler
look around the bottom of the motor at the rear of the block on both sides. it should have a thick battery cable attached to it and a couple of smaller wires attached to it, one on the solenoid and one one the same terminal as the thick battery cable
hope this helps you
SOURCE: Where is the crankshaft position sensor located?
the crankshaft position senor on the 2.2L is located on the rear right side of the engine block
SOURCE: I can't locate the fuel filter on my 2004 chrysler
I would check if it is in the gas tank on that model. you can go to your local parts store and they should be able to inform you of this.
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
894 views
Usually answered in minutes!
×