My 92 mazda stopped starting, if i depress the petal even once i can smell gas. Im getting spark, i put new wires in and plugs and a new cap and rotor. I checked my fuses but still no luck. It also died if i depressed the clutch while running after a few minutes. it only idles in neutral.
SOURCE: MAZDA MX5 CAR, WHINE FROM
a little whine can be normal what is happening when you push clutch in mainshaft in tranny quits spinning. with clutch out it is spinning with engine so could be a bearing going out
SOURCE: i have a 92 mazda
I BELEIVE MY TROULBE IS THE IGNITON MODULE IN THE DISTRIBUTOR,STALLS AND HARD TO START
SOURCE: mazda 626 will not start..no spark
Hi,
Offhand, a lot of possibilities that can cause no spark and/or deteriorating performance.
The correct procedure would be to have the car's computer scanned for the error codes. The error codes would give us a general idea where to begin diagnosis/tests. There are a number of known shops that would do the scanning for free and provide you with the error codes.
Hope this be of initial help/idea. Pls post back with error codes, how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.
SOURCE: 626 won't start no spark
Distributor fault, the coil goes down in tyhem and sometimes pops the ECU.
SOURCE: 92 mazda mx3 will crank but will not start but
i dowt it did u check the iac valve stands for idle air control valve or possibly ect sensor
131 views
Usually answered in minutes!
×