Welcome to FIxYa.com
Blower Motor Resistor and Controller Replacement Image Blower Motor Resistor Or Controller/Power Module Remove/Install REMOVAL 1. Disconnect and isolate the batten' negative cable. 2. Depress locking tab and unplug the wire harness connector
from the blower motor resistor or controller (power module). 3. Depress locking tab and unplug the resistor or controller
connector from the blower motor. 4. Remove the 2 screws that secure the blower motor resistor
or controller to the heater-AC housing. 5. Remove the blower motor resistor or controller from the
heater AC housing. INSTALLATION 1. Install the blower motor resistor or controller to the
heater AC housing. The housing is indexed to allow (controller power module)
mounting in only one position. Tighten the mounting screws to 2.2 Nm(20 in.
Lbs.). 2. Plug in the wire harness connector to the blower motor
resistor or controller. 3. Plug in the connector from the blower motor resistor or
controller to the blower motor. 4. Connect the batten' negative cable.
Thank you for using FixYa.com
Regards, Lee Davidian
30 views
Usually answered in minutes!
×