Codigo p1698 in sebring |1997

No CCD Messages Received From TCM. Have code cleared and see if it returns.

See if resetting your ECC (ECM) called the computer will get rid of these problems. You do it by unhooking both battery cables, waiting at least 15 minutes and rehooking the battery. No security thing, only the fact the computer needs new settings for the parts you installed.

You will need to retrieve the trouble code(s) stored in the computer and repair the problem associated with that code.You cab buy a tool for less than 70 dollars that will read and erase the code at a chain parts store.This is not a maintenance light or an oil change indicator.This light is part of the onboard diagnostics.Good luck!

P1698 Chrysler

ECM fault-No CCD message from TCM
- Failed ECM

Probable Cause[s]

1. Open CCD bus line
2. Failed TCM

P1495 Chrysler

EVAP leak detection pump solenoid circuit condition
- ECM detected the pump solenoid did not change status when activated

Probable Cause[s]

1. Pump solenoid defective
2. Open or shorted circuit condition
3. ECM Defective

Code P1698 means
* P1698 PCM Failure EEPROM Write Denied
* P1698 -No CCD messages from the Transmission or Body Control Module (TCM or BCM) Probably needs a new PCM (Aka computer or ECU)

The 1698 code means either that there is no digital data communication from the the transmission controller OR from the body controller that is being received at the powertrain control module. An analyzer that read "hex" codes would distinguish which, the former being a 60 the latter a 61 hex code.

follow the link listed in here

http://www.fixya.com/support/r4161093-trouble_codes_vechiles

code1494 leak detection pump switch does not respond to input. code 1698 no message received from transmission control module. hope this will help !!!

no message received from the transmission control module. The bus system is the communication system the computers use to send information back and forth. Anything from a bad fuse, bad wire, or a faulty computer can cause that code.

off the top of my head I am not sure w\hat exactly that code is although I do now it sound familiar. Most code tat are p one codes are usually more of an electrical problem or even a sensor. For that code all I can say right now is possibly a speed sensor issue or wiring