I need to remove the shifter knob. It does not appear to screw off like one would expect.
SOURCE: shifter knob removal
the shift knob is glued and pressed on, the best way to remove it intact is to heat the knob with a heat gun and pull straight up with a lot of force, please be very careful because when the knob finally releases there is very good chance that you can hit yourself in the face, if the knob is not to be used again you cut a **** up the side with a dremal tool,
SOURCE: how do you read the oil dip stick on a 1996 saab 900
Just go by the marks,Pull the dipstick,wipe it,reinsert it,pull it agian and read it.Please rate this a fixya
SOURCE: 96 Saab 900 Clutch Cable: Manual vs Self-Adjusting
I did mine too and used the manual adjustable one as it should technically not wear as quickly as auto adjusting. No issues, no difference in *feel*
SOURCE: I'd like to replace the stock shifter knob (or
Usually there is a nut on the bottom of a shift knob that needs to be loosened, then the knob just screws off. Use a wrench, if it's hexagonal, if it's just round or there is no nut it may just screw off. It will be really tight though, be prepared to have to really crank on it to get it loose. The new one should just thread back on. You may need to install a nut on the bottom to adjust the rotation of any pattern or gear shift diagram on the new one.
SOURCE: removing shifter knob on 07 chevy equinox
There is a set screw under the crome ring at the bottom of the shifter knob. use a small flat screw driver and pry down on the chrome ring and it should come down and the set screw is under the chrome ring
726 views
Usually answered in minutes!
×