Chrystler 200 2013 having problems cranking - 2013 Chrysler - 200

P1684 CHRYSLER - Battery Power To Module Disconnected
https://www.autocodes.com/p1684_chrysler.html

P0340 CHRYSLER - Camshaft Position Sensor Circuit Bank 1 Sensor 1
https://www.autocodes.com/p0340_chrysler.html

P1685 CHRYSLER - Invalid SKIM Key https://www.autocodes.com/p1685_chrysler.html

It should be attached to transmission block, I will see if I find a diagram.

First try to turn engine with a spanner, if the engine is turning then check your startor motor and make sure your car is in park possition.

Hi MZ, The crank shaft pulley is the thing that has the fan belts running on it. Are you looking for the crankshaft position sensor? Regards John

Hi there:
The crank (CKP) sensor is located on the bell housing,{rear of engine block}and is a ****** to get to.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

test............

Boost it. Red to positive battery, black to engine ground. Donor vehicle red to positive black to negative on battery.

Are you using the rod and turning the crank to lower the spare tire? There will be a little hold along the trim of the trunk opening by the top of the bumper. You need to insert the rod into this hole and crank it to lower the tire

Check and make sure that the engine is not seized up. Does the engine turn over?

Ignition switch is the most likely culprit.