20 Most Recent 2013 Chrysler - 200 Questions & Answers

0helpful
1answer

What can cause floor in the back, (behind the front passenger seat) to be soaked with water (& I mean SOAKED) ?

I assume there are no leaks in the windows or sunroof. One probable cause, is the Air Conditioning unit. On all cars there is a drain line for the AC unit. As a unit runs, it produces condensation. (Just as a bottle of cold water produces condensation in a warm, humid area). That water has to go somewhere, so there is a drain at the bottom of the system. That drain (which comes out under the car, usually centered under the dashboard area), can become clogged or pinched and leave the water to accumulate in the system base, (again inside the car, under the dash). When this happens, the water will seep under the carpet and find the lowest area, which in this case, is the floorboard in the back seat area.
3/12/2022 8:26:54 PM • 2013 Chrysler -... • Answered on Mar 12, 2022
0helpful
1answer

Transmission 2013 Chrysler 200/stalling

Engine is stalling or transmission quits pulling ?
2/13/2021 5:25:20 PM • 2013 Chrysler -... • Answered on Feb 13, 2021
0helpful
1answer

Electric mirrors on 2013 cgrysler 200 are not working. how do I fix it

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals
3/8/2019 9:36:50 AM • 2013 Chrysler -... • Answered on Mar 08, 2019
0helpful
1answer

Will the AC ACtuator make my heater blow cold and not hot on an 2013 Chrysler 200

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few for now u can try reliable-store.... let me know if u need help thanks
2/16/2019 10:08:07 AM • 2013 Chrysler -... • Answered on Feb 16, 2019
0helpful
1answer

No heat on the passenger side of a chrysler 200 2013

The actuator for heat is located up behind the glove box. These actuators are made of plastic and tend to strip. They are not expensive, and you can find videos that will show you how to replace. Good Luck Friend.
2/9/2019 11:09:34 PM • 2013 Chrysler -... • Answered on Feb 09, 2019
0helpful
3answers

My 2013 chrystler 200 2.4 lstarter smokes an smells burned up i replaced it an same thing when i start the car it sound as if its stuck ingaged an the fuse box dosent say witch is the starter relay

Your starter can stick for multiple reasons but there are shims available to position the starter to where it doesn't catch on a flywheel this also will make the solenoid stick and not disengage you should always bench test a starter before putting it in your vehicle any auto shop can do this. Also it's very important to check the wires going to the starter if they're degrading or if there's corrosion build up internally inside the wires they will not allow the proper amps and voltage to flow to the starter. The electrical flow is very important for the cellular to function properly and also make sure the contact surfaces between the bellhousing and the starter are cleaned is grounds the unit
11/8/2018 6:27:05 AM • 2013 Chrysler -... • Answered on Nov 08, 2018
0helpful
1answer

Change heater core in 2013 Chrysler 200

Entire dash must be removed to replace it. Expect 10 to 12 hours if you are experienced with this job. Ac system may even need to be discharged.
10/8/2016 11:53:15 PM • 2013 Chrysler -... • Answered on Oct 08, 2016
0helpful
1answer
0helpful
1answer

No audio controls

for the best solution of your problem visit this site Best Manuals
4/25/2016 5:29:58 AM • 2013 Chrysler -... • Answered on Apr 25, 2016
0helpful
1answer

How do I replace the directional switch

Take both column shrouds off to access the multi function switch
4/9/2016 7:35:03 AM • 2013 Chrysler -... • Answered on Apr 09, 2016
0helpful
1answer

How to get in locked 2013 Chrysler 200

Locksmith, or the dealership can cut you an extra key off of the VIN number with proof of ownership.
4/8/2016 8:40:31 PM • 2013 Chrysler -... • Answered on Apr 08, 2016
0helpful
1answer

Touring. How can I remove and replace the tail light assembly?

Google this: Chrysler 200 Reverse Tail Light Bulbs Replacement Guide
3/20/2016 5:14:43 AM • 2013 Chrysler -... • Answered on Mar 20, 2016
0helpful
1answer

When i use the turn signal my dash lights dim whats the problem

probably a bad ground point for the indicator lights in the dash
11/11/2015 2:56:57 AM • 2013 Chrysler -... • Answered on Nov 11, 2015
0helpful
1answer

When i use my turn signal my dash lights go dim

BULB SOCKET DAMMAGE ON THAT SIDE OF TURN DIRECTION (FRONT OR REAR) ?
11/11/2015 2:52:16 AM • 2013 Chrysler -... • Answered on Nov 11, 2015
Not finding what you are looking for?
2013 Chrysler - 200 Logo

29 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Chrysler Cars & Trucks

  • Chrysler Cars & Trucks

Most Popular Question

cause floor in back behind front

  • Cars & Trucks
Loading...