Top 20 2007 Mazda MX3 Questions & Answers

NOT SURE WERE FREEZE PLUGS ARE LOCATED ON YOUR MODEL , BUT WORTH CHECKING OUT!

Wank your cars gearknob. the flashing light means its ****.

locate your air your airfilter housing there may be a vent in the side or top clean this with a tooth brush as it gets cloged with dirt and oil.had same problem but with earlier model.

clutch is not disengaging when pedal is pressed no hydraulic fluid slave cylinder leaking clutch master cylinder failure air in system clutch cable broken take it to a clutch and brake specialist shop not a clutch problem

I think someone has misled you. Even if you were able to get it to work by tapping it, you can be sure the problem is going to come back. You need to have that starter tested if you think it is the problem.

Could be a shaft can you smell smoke under the hood if it's the clutch you could smell it burning

Welcome To MX 3 com Your Complete Source On The Mazda MX 3 http://www.mx-3.com/ check above url for assistance ....it is dedicated to your vegicle's model

Why did you replace fuel pump? Did you buy a dealer pump or cheap aftermarket unit? Just because it is new does not mean it is good. Have you run pressure test?

Check the cabling and the relay, if the bulbs are ok.

run the fault codes and check for faulty MAP/MAF/VAF sensors

Mr. RAGSDALE. I do not know if you did strip the belt yet or not. If you did not,I will advise you a just easy and good way to do it yourself. String for the stripping,you just remove the outside belts and pulleys,remove the plastic covers of the timing belt. Just put on the crankshaft the pulley bolt and slowly slowly turn the engine until you see all the marks aligned. On the Camshafts the two sprockets do have the letters "E" and "I", E= Exhaust and I= Inlet.means that the inner to dashboard side is the inlet cam and to the vehicle front the exhaust cam. These two cams with the letters must be aligned,with the crankshaft sprocket having on the side a small groove which mus be aligned with a small point ball behind the sprocket on the cylinder block. There are your marks. Loose the tensioner and remove the belt. Good Luck!

Engine Number Either on the rear top nearside or on the front nearside of the block. On V6 engines the number can be found on the rear nearside of the block.

ma be the selinoid they seem to all go at the same time

clutch plate worn causing slipping no increase in speed or transmission fluid low or transmission fluid old contaminated, transmission need fluid and filter change.could have fault in the kick down solenoid or over drive cancel solenoid.have transmission shop code scan look for faulty shift solenoids or speed sensor fault code,lock up solenoid got a lot of parts any one of them cause no over drive.

the a/c pulls it power from the engie, so the engine need to be in good operating condition. it may need a tune-up to maintain its rpm level.

replace the voltage reulator some have it internal of the alternater if so then you need to replace the alternater

Is it leaking FROM the oil pan, or dripping OFF the oil pan?

If its dripping OFF the oil pan, that leads me to beleive you have a coolant leak somewhere. Check the coolant level. Check for leaks.

Check your oil, if the oil is milky/coffee colored. Or if your coolant looks kinda nasty, you may be looking at a headgasket.

"horn, fan defroster, heated seats"
;)

These are stabilizer bars. you can get bushings for them

Yes to both.