Pramac Logo

Pramac Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 100 Products
  • 167 Answers
  • 27K Views

Voltage regulator isn't working..

Pramac 2800 Watt... | Answered on Jan 13, 2014


The internals of the generator have to be removed and you'll need a gear puller to seperate the engine from the generator housing because they're pressed together. It can be a pain in the neck. There's videos on you tube on how to do it

Pramac... | Answered on Nov 27, 2013


Timing gears? have you pulled it that far apart? On timing gears there are usually stamped onto the gears a small dot. lign them up. Not sure why tore down so far? If you take off the diesel pump align the timing marks in the small window plate first else you will be in a mess.

Pramac GBW30P... | Answered on Nov 17, 2013


You have the remote control wires incorrectly connected either at the ATS or on the generator control panel, disconenct from both ends and ohm them to make sure they are not shorted between. Then reconnect them at the generator end only. Then join them together manually, of the gen starts and stops when taken apart, the problem is in the transer switch, or incorrect terminated

Pramac GBW30P... | Answered on Nov 16, 2013


you will require access to the end of the alternator from the drawings on the pramac site the alternator looks like it could be made by mec alte spa if so there are spec sheets on their site for the alternators, remove the end cover of the alternator and there should be a bridge rectifier in there which will need testing also the spec sheet should give the resistance of the coils so you can check them you will need info from the data plate on the alternator, if it is mec alte spa then find your product herehere

Pramac P6000... | Answered on Nov 04, 2013


clean out the carb

Pramac... | Answered on Nov 04, 2013


If you have a Yanmar engine...
There is a hose that is connected to the oil pan in place of the drain plug directly under the oil filter that will have an end cap. This hose is used to drain the oil into a waste container.
Download the service manual located at the address below and follow the instructions in the manual.
http://www.martindiesel.com/Documents/New%20TNV%20DIRECT%20Service.pdf
Hope this helps.

Pramac... | Answered on Aug 22, 2013

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pramac Experts

Marvin
Marvin

Level 3 Expert

84524 Answers

Lawrence Oravetz

Level 3 Expert

10528 Answers

wadingriver
wadingriver

Level 3 Expert

2222 Answers

Are you a Pramac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...