Pramac Logo

Pramac Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 100 Products
  • 167 Answers
  • 27K Views

most have a rubber grommet that goes in the hole in the bottom of the tank and the shut off valve goes in the center

Pramac Generator... | Answered on Sep 08, 2012


Fresh Gas? Gas line on? Run/stop switch on Run? Plug wire connected?

Pramac 3000 Watt... | Answered on Aug 30, 2012


WURTH, supply various adhesives suitable for use with fuel systems

Pramac 5000 Watt... | Answered on Aug 27, 2012


Approximately 3.5 hours at 50% Load

Pramac EG2800 T... | Answered on May 09, 2012


Is there a spark? If yes, then the fuel supply is blocked, either in the tank, hose, or carburetor. Enough fuel gets by to run a small load, but a bigger load starves it of fuel. The empty carb bowl makes it hard to start until enough fuel gets into the bowl. Clean the whole fuel system and all should be well. Try turning in all the carb adjustment screws then backing them off to their original positions, that may unclog something before you have to tear the thing down.

Pramac... | Answered on Sep 29, 2011


Hi,
If a generator sits unused for a long enough time the generator magnets will loose their power and need to be "flashed" or recharged so that the generator will start to work again...

Here is an interesting discussion about that...

http://www.doityourself.com/forum/outdoor-gasoline-power-equipment-small-engines/188605-recharging-generator-field.html


Here is another way to do it..

http://www.homeownershub.com/maintenance/How-to-flash-an-AC-generator-241161-.htm


heatman101

Pramac... | Answered on Aug 13, 2011


If you have an oil level switch on this generator, it could be that you have low oil level or the switch is bad. Check the oil level. Bypass the oil level switch.

How old is the fuel in the tank, and how full is the tank? Fuel goes bad with time due to the ethonol turning to gummy varnish like substance. Not keeping a tank full allows condensation to form on the inner walls, contaminating the fuel with water. Drain the tank completely and fill with new gasoline.

How did you "clean the carb?" If it was not completely disassembled, soaked in carb cleaner, and all jets and ports blown out with air, you could have blockages from the "bad gas."

BigDaddyPat

Pramac 5000 Watt... | Answered on Jul 24, 2011

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pramac Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

Lawrence Oravetz

Level 3 Expert

10528 Answers

wadingriver
wadingriver

Level 3 Expert

2222 Answers

Are you a Pramac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...