Frigidaire Freezers - Page 7 - Recent Questions, Troubleshooting & Support

I would guess the control panel is failing, but due to the cost of the part have a technician come out and confirm that is the issue. You can also go to www.partsdirect.com and email the forum

Check along the back and sides of the freezer for any vent-like openings that are covered or blocked by packages. There may be a sensor that's not getting air flow as it should. Although most upright freezers are now frost free, there still can be ice buildup in critical areas such as the thermal sensor or the fan. Can you tell if the fan is running? Even if the compressor has failed, your frozen items will keep the temp down for several days. I suggest you move the frozen goods to a neighbor immediately. Meat or fish in particular quickly becomes unsafe to eat without at least refrigeration.

Here's a link to a manual Linda. http://www.searspartsdirect.com/partsdirect/user-manuals/FFU2064DW2-Frigidaire-Parts-Freezer-Parts-manual

Is it iced up.if so,then turn off and let thaw out.

May be just the thermostat or the start capacitor on the compressor. Still cheaper that buying a new one.

First make sure its input power supply is as per required coming or not if its OK then check thermostat device it may can faulty kindly check it if its required then need to replace it .

Hope answer the question

I see your post has been here for a while it sounds like the control board itself not wiring what have you found since June xxi? User Control and Display Board 5303918341 http://www.appliance911seabreeze.com/

It is on the back wall, about 2/3 of the way to the floor on the right hand side... Knob will look like this: Frigidaire Freezer Control Knob 216707200 You probably have food in front of it!

A bad door switch, or a defective control

Unplug it for a minute

If the sides are hot, look at the defrost timer. Sounds like it has stopped running with the defrost elements on. The compressor has a safety switch on it that opens either if the compressor gets too hot or if it pulls too much current when starting. If your power flickered a lot before coming back on, that triggered the safety switch. Now that it's running normally, I wouldn't worry. The defrost timer is your problem now.

It is over-filling and the cubes are fused together... If the fill is adjustable, lower it, but you may need a new water valve... Frigidaire Water Inlet Valve 242252702

That is usually a signal meaning the door switch is being sensed as open... Make sure the light goes off when you press the switch, if it does, buy a new control... OR remove the control and break the little round speaker off of the board to quiet that thing.

they run around the entire perimeter... Just put something heavy on the top of it.

Make sure the unit is not plugged into a GFCI outlet...

opening burned out compressor.

If the control is "ON" and the compressor is not running, you will need a start relay... Make sure you didn't accidentally turn it off by pushing food against the control knob!

There are some products that you can put on rust that cause it to harden and stop if from spreading, You would then have to repaint the door.

Good Afternoon Friend, I understand your Frigidaire freezer runs for a short time and then kicks off. Then it turns on with a click and repeats its cycle. This is how your freezer functions. When it needs to cool, the compressor will kick on and cool until the temperature is reached. Then it will kick off until it needs to cool again. It's possibly due to the hot and humid summer that it is cycling on and of more. I hope this is helpful. -Best Regards- WP