Electrical Supplies - Page 2 - Popular Questions, Answers, Tips & Manuals

That means the capacitor is bad

You still need to change the capacitor

There are many ways to start. First, the starter is weak, and the second is that the starter does not move. If the latter, check the controller for signal output. If there is no signal output, check the battery for voltage? If there is pressure, the controller may be broken.

you would really have to check with the dealer or see if there is a place for one. some come with a starter upgrade and some dont

Save money and replace fluorescent tube with led light what doesnt require balast

;) you wearing rubber boots?? Electricity is supposed to travel down to the ground but if your feet are rubberized then it will not work

watts = 0.8 × 2A × 120V = 192W watts = 0.8 × 1A × 120V = 96W watts = 1 × 1A × 120V = 120W

Normally there is a protection fuse between the low voltage charge winding and the regulator, that may be blown if the battery voltage does not hovver at about 13.8 volts when running otherwise the regulator itself may be faulty. A standard small battery charger runnibg off the power will keep you going until it is repaired.

What you need to do is to change the switch and it will work

yes. have you tested the battery to make sure it's good and can take a charge and hold it.

check the starter bendix. might just need lube or new one

Check your oil. If you don't have good oil pressure it will shut down. If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

you are going to have to get right into it and test all the wiring for voltage or there could be problems in the windings. and that is the only way to find out

The other wire is the positive wire

Try plugging something else into those outlets and see if they work, or try plugging the mixer into an outlet that you know is working. If it still doesn't work it may be the plug on the mixer or broken wire on the power cord. Examine the power cord and look for any weak spots or damage to the cord or where the wires go into the plug. Usually the wires tend to break right where they go into the plug from bending or wear and tear. If that's the case all you need to do is buy a new plug cut the old one off and install the new plug.

fiddling fingers have caused you a problem best get in an electrician to check the wiring and fix it properly

hi this type ( if not most of them ) has only one terminal positive because when the fence is touched the intruder is the negative terminal hence causing shot circuit ( discharging the electric to the intruder )

there should be a plate on it for wiring 120 or 240 if not need model number. easy fix

sounds like a gasoline engine problem.

hi jackie. i have had a look around but at the mo can not find one,but have you tried ebay?.