Questions & Answers for: polygon mirror

polygon mirror motor does not reach operating speed within 10 seconds after the motor ON signal is sent, or does not turn on within one of the 200 ms check intervals during operation. ? Polygon mirror

...Polygon mirror motor error: Symptom: Did not detect lock signal from polygon mirror motor within 10 seconds after motor ON signal; or, lost lock signal for continuous 1.5 seconds after signal was ...

polygon mirror motor does not reach the operating speed within 10 sec or the polygon motor remains out of the operating speed.Possible cause:defective polygon mirror motor,loose connection between the

...for more than 200 ms continuously during operation. Possible Cause • Polygon mirror motor defective • Poor connection between the polygon mirror motor driver and the SBCU board • SBCU board ...

...polygon mirror motor fails or poor connection between BICU & polygon mirror motor please check first the connector of motor if you feel that the connector is good change the polygon mirroe motor ...

...Polygon mirror motor defective · Poor connection between the polygon mirror motor driver and the BICU board · BICU board defective first of all go to the sp mode table in the ...

sc335 ricoh 2045 copier Code: 335 Description:Polygonal Mirror Motor Error 1: ON Timeout The XSCRDY signal is not issued (LOW: Active) within 25 s after the polygonal mirror motor switches on. Causes:

...polygon mirror. In this machine, it is two mirrors placed on top of each other. The motors job is to spinn the missors fast and at a steady speed. Several thousand RPMs. The lasers in the machine is ...

...Polygon mirror motor problem. 1. Try to turn the main switch off and on. 2. Check the wires. 3. Check the polygon mirror motor PCB connector (bad, loose or broken) 4. Polygon mirror motor no good 5. ...

IN PRINTING AN ERROR SC491 IS GIVING.KINDLY REPLY WITH SOLUTION. Polygonal Mirror Motor Cooling Fan Motor Lock The polygonal mirror motor cooling fan motor lock signal remains HIGH for 5s while the ...