...ink cartridges and touch the pad on the bottom with a Q-tip (one for each color). If there is color the cartridge pad is OK. Take a fresh Q-tip dip it in rubbing alcohol and GENTLY rub the little ...
...ink pad, you can try soaking the roller with the ink so the roller is wet, (but not DRIPPING WET) and try it again in the calculator. IF you get some image for a little while, then I would say try a ...
...where they don't close and pour ink out. On occasions ink will dry in the nozzle and ruin it. To fix it usually requires you to take the printer apart and wash the ink out of the pad and
Question about X1240 All-In-One InkJet Printer
...ink at bottom plate of head. Print blank pages for cleaning itself. You can clean it by put wet tissue at bottom side of head. Turn off printer, move head to center. Put wet tissue at pad. Move head ...
Question about PIXMA MX310 All-In-One Printer
...pad. Lift the cover to expose the ink cartridges and place this pad over the ink absorber on the LHS of the printer so the pad soaks up the wet ink. Repeat until the absorber is nearly dry. Look
...ink pad(s). On the RX700 there is a small access panel, on the back of the unit, on the left hand side when facing the back of the RX700. It is held in place with a Phillips head screw and small ...
Question about Stylus Photo RX700 All-In-One InkJet Printer
...ink pad on the right side of the printer for the night or when not in use, sometimes this gets clogged or dried. when the carrage is all the way to the left unplug the unit. this way you will have ...
...ink on the pad o clean the printhead nozzles. The printer is programmed to count these cleaning cycles and when the number is up it gives the ink absorber error on the display. The printers use the ...
Question about DCP-350C InkJet Printer
...pad will soak the blockage and draw ink through the head. Give the machine two self cleans and try a print quality test to see if you have made ANY improvement. If no improvement - forget it as the ...
Question about PIXMA MP190 All-In-One InkJet Printer
...ink absorber pad jumped out as I was pulling on the rubber cradle and stuck to something, being wet with ink, and I could'nt find it. My hand were too big to do the job sucsessfully, Time for a new ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions