Question about 2002 Grand Cherokee
break There is a switch on the dash that raises the break and gas pedal.Only the break pedal will come up or let down.Hope you can help.Thanks Donnie Most likely the motor that raises the brake pedal
...break light sensor, but i dont know where it is. can anyone tell me where the sensor is located? or even if it isnt the the sensor, then whats the problem? check the brake switch located on a bracket ...
Question about 2000 Grand Cherokee
...break switch{thing down by the break pedal with all the wires} is closed i am not getting any voltage at the rear [lft and rht] break lights. i found which pins go to each light and I tried to bypass ...
...break light switch, new headlight switch, new bulb connectors, fuses. anyone know of anything else i could try hi silly thing to sugest but would you have the brake/side light bulbs in the wrong way? ...
switch, the break lights go on or off. Not sure how much they run, but really easy to change. You could also check the switch with an ohm meter if available by making sure it breaks or runs continuity
...the break light switch my break lights arn't working but the fuses are gd? help what amp are the fusees u are using for the break lights and have u checked all wires for the break ...
Question about 2001 Grand Cherokee
break switch is and I don't know how to find it. :( hellppp. Thanks. look under dash follow the brake peddel up you will see the metal arm riding on a switch it needs ajusted so the peddle arm
Question about 1999 Grand Cherokee
...is the break light relay on a 99 jeep grand cherokee Generally, the break light switch is located top back side brake pedal; also check in THIS DIAGRAM position 23 for Brake Switch fuse. Hope
...break fluid in it. hi see if there is a switch behind the brake peddle,undo one of the connectors,then switch ignition on and see if the brake lights have gone out,if so replace falty switch. good ...
...switch is right over your break pedal. it is a small piece with 2 wires. Disconnect the wire form the switch and try to bridge the contacts f.e. witch an paper clamp. If the break lights goes on, ...
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions