Need to replace dryer belt, inglis - Dryers

https://www.whirlpoolparts.com/PartSearch/ProductBrandAllModels?brandId=361&productId=8

as it states...If our list of models doesn't contain your Inglis Dryer model number, call our Customer Service team at 1-800-269-2609 or start a Live Chat for help.

Replace the belt - it is old and worn out. The belt is made of rubber and is slipping, causing the smell and squeak. The belt heats up and becomes more flexible after the dryer runs a while; this is why the squealing stops.

The way to visually see if the belt has broken or not is to 1) unplug the dryer. 2) Remove the lint screen on the top of the dryer. 3) take the two phillips head screws out where the lint trap is. 4) with a flat head screwdriver pop the top of the dryer up by sliding the driver inbetween the top and front of the dryer and pry upwards a little. 5) You'll now see the drum, if the belt is not around it its broken, and if it's visible try to lift it. If it taught, its good. IF THE BELT IS BROKEN OR LOOSE CONTINUE TO NEXT STEPS 6) on the left and right upper inner sides of the dryer you will find two screws, one on each side, remove these and the front should be easlily remove. 7) once off you'll be able to easily see the motor, the belts idler pulley, and everything else.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

broken belt,that's what spins the drum

Sorry for the troubles but you cant tighten the belts on those or any dryer for that matter. Here is the problem your belt is worn out and that's why it is loose and if you have replaced it and its loose you are installing the belt incorrectly around the idler pulley or have the wrong belt or your idler pulley is worn out. I hope this helps solve the issue your having and for instructions on installing the belt go to youtube and type in whirlpool dryer drum belt installation they will show you the correct way to do it and whirlpool builds your model dryer.

Hi,

I think you're requesting info on how to route the drive belt, aren't you ?

If that is indeed what you're wondering, the image I've attached should help. It is the Whirlpool/Kenmore image you'll want to go by, Inglis is Whirlpool.

If not please let me know and I'll see if I can assist you further. If this does answer you're question please allow a second to rate the info I provided here.

Thank you for visiting "fixya" and good luck.

macmarkus :)

Diagram A

Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram B
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram C
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram D
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram E
Style: Flat with ribs
Installation Tips: Flat side of belt against drum
Diagram F
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram G
Style: Flat belt
Installation Tips: Side of belt with words faces away from drum
Diagram H
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram J
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram K
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram L
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram M
Style: Flat with ribs
Installation Tips: Ribs against

1. Changing from 3 to 4 wire hookup on a electric dryer
   
2. Door switch replacement help for a common door switch
   
3. Dryer basics - Venting problems and power supply
   
4. Dryer basics - timers and how they work
   
5. Dryer basics - power cord problems
   
6. Dryer basics - dead dryer
   
7. Dryer *general* repair flow chart....Click here
   
8. Gas dryer smell
   
9. How do dryer thermostats work?
   
10. How long can my dryer vent be in length?
    
11. How to change a common rear drum seal
    
12. How the belt is suppose to look at the motor and idler pulley
    
13. Help on replacing dryer motor and some wiring tips for the 279827 motor
    
14. Help on replacing dryer motor and some wiring tips for the 279787 motor
    
15. Help for storing an appliance
    
16. Important Disclaimer
    
17. I dropped something down the lint filter area....help!
    
18. Inglis, Whirlpool and Kenmore most common style dryer - how to take apart ( lint filter on top )
    
19. Inglis, Whirlpool and Kenmore most common style dryer - how to take apartslide show( lint filter on top )
    
20. Whirlpool or Sears dryer with heater on the floor and four rollers for drum style - take apart helps ( lint filter in the door )
    
21. Inglis, Whirlpool and Kenmore electric style dryers - no heat problems
    
22. Inglis, Whirlpool and Kenmore electric element changing procedures
    
23. Inglis, Whirlpool and Kenmore dryers - air flow
    
24. Inglis, Whirlpool and Kenmore style dryers - noise problems....drum rollers and idler pulley information....
    
25. Inglis, Whirlpool and Kenmore style dryers - belt change
    
26. Inglis, Whirlpool and Kenmore dryer general motor problems
    
27. Inglis, Whirlpool and Kenmore gas style dryers - no heat problems
    
28. Inglis, Whirlpool and Kenmore dryers - where are my thermostats
    
29. If your drum belt looks like either of these....change it!!
    
30. Idler pulley slide troubles with newer Whirlpool build Roper dryer
    
31. My dryer will not shut off
    
32. Newer style Whirlpool - Inglis - ( some ) Kenmore dryer front drum support ring install help
    
33. Pilot flame help
    
34. Sample wiring diagrams
    
35. Test for ohm meter checking on electric dryers with no heat
    
36. Taking apart an Duet or HE3 dryer for a belt change
    
37. Taking apart a Whirlpool Thin twin washer/dryer to replace the belt
    
38. Timers and some common Auto dry troubles and solutions
    
39. What is a grounded element?
    
40. Whirlpool - Kenmore dryer motor problems in the dryer with Even HeatControl....info on this is here + Expanded repair helps for a common "Even Heat" dryer
    

1. Changing from 3 to 4 wire hookup on a electric dryer
   
2. Door switch replacement help for a common door switch
   
3. Dryer basics - Venting problems and power supply
   
4. Dryer basics - timers and how they work
   
5. Dryer basics - power cord problems
   
6. Dryer basics - dead dryer
   
7. Dryer *general* repair flow chart....Click here
   
8. Gas dryer smell
   
9. How do dryer thermostats work?
   
10. How long can my dryer vent be in length?
    
11. How to change a common rear drum seal
    
12. How the belt is suppose to look at the motor and idler pulley
    
13. Help on replacing dryer motor  and some wiring tips for the 279827 motor
    
14. Help on replacing dryer motor  and some wiring tips for the 279787 motor 
    
15. Help for storing an appliance
    
16. Important Disclaimer
    
17. I dropped something down the lint filter area....help!
    
18. Inglis, Whirlpool and Kenmore most common style dryer - how to take apart ( lint filter on top )
    
19. Inglis, Whirlpool and Kenmore most common style dryer - how to take apartslide show ( lint filter on top )
    
20. Whirlpool or Sears dryer with heater on the floor and four rollers for drum style - take apart helps ( lint filter in the door )
    
21. Inglis, Whirlpool and Kenmore electric style dryers - no heat problems
    
22. Inglis, Whirlpool and Kenmore electric element changing procedures
    
23. Inglis, Whirlpool and Kenmore dryers - air flow
    
24. Inglis, Whirlpool and Kenmore style dryers - noise problems....drum rollers and idler pulley information....
    
25. Inglis, Whirlpool and Kenmore style dryers - belt change
    
26. Inglis, Whirlpool and Kenmore dryer general motor problems
    
27. Inglis, Whirlpool and Kenmore gas style dryers - no heat problems
    
28. Inglis, Whirlpool and Kenmore dryers - where are my thermostats
    
29. If your drum belt looks like either of these....change it!!
    
30. Idler pulley slide troubles with newer Whirlpool build Roper dryer
    
31. My dryer will not shut off 
    
32. Newer style Whirlpool - Inglis - ( some ) Kenmore dryer front drum support ring install help
    
33. Pilot flame help
    
34. Sample wiring diagrams
    
35. Test for ohm meter checking on electric dryers with no heat
    
36. Taking apart an Duet or HE3 dryer for a belt change
    
37. Taking apart a Whirlpool Thin twin washer/dryer to replace the belt
    
38. Timers and some common Auto dry troubles and solutions
    
39. What is a grounded element?
    
40. Whirlpool - Kenmore dryer motor problems in the dryer with Even HeatControl....info on this is here  + Expanded repair helps for a common "Even Heat" dryer