Frezer is cold refrigerator is warm - Haier HTE18WAA Top Freezer Refrigerator

Hi,

Check out these tips...they can help you figure out what is going wrong withyour refrigerator and why it is not cooling

Refrigeratornot Cooling or Fridge not Cooling

How to Defrost Refrigerator DefrostTimer Problem

WaterRunning in refrigerator from Freezer

Refrigeratoror Freezer not Cooling or Getting Cold
heatman101

Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing thencheck out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101
[ [ [

Hi,
Here are a couple of tips that I wrote that will help you figure this out...

http://www.fixya.com/support/r3771673-defrost_refrigerator_defrost_timer


http://www.fixya.com/support/r3885294-refrigerator_troubleshooting

heatman101

If it is the pss26msrss or close I can tell you that it is most likely the defrost heater and defrost thernostat that needs changed, Would you like me to show you how to do the test. First tell me if a layer of frost is building on the rear wall of freezer. If yes unplug and remove rear panel until we see the defrost heater at the bottom of the evaporator coil. let me know, Sea Breeze

weak evaporator fan!!! :)

likely door gasket door out of alignment. or the defrost high limit switch is not opening in defrost when the evaporator get warm during defrost check the door gaskets good and clean. Tom

Heat exchanger was iced over, took a hair dryer and melted ice. I think defrost heater element is bad will check it this week end. I put a new computer in the frige about 3 mounths ago and will check if it has gone bad. The compressor is working fine.

it.s the frezer that makes the refer cold.the evap fan in the frezer moves that chilled air to the refer.if that fan is slow or any blockage inthe air ways it slows that process.Also the frezer should be close to 0 degrees if theres a defrost prob that would make fresh food warmer

check the fan in the frezer and check the defrost