Hi I have a Winner 11 by Karcher. the hose blew a hole in it am wanting to replace it. The only numbers that I can find are N1417 or S/N185140 or Q60004 are any of these going to make it easier to work out. Cheers Steve

If hose fits over a hose barb try using a hose clamp from any auto supply store Or replace the hose barb GL

from where?

use high quality brass fitting, low quality brass will break also,replace male and female side with matching brands

possibly a heater hose leak or maybe a freeze out plug

http://www.rjbowers.com/machine_list.php Click on blue search list box - type winner in box - hit enter key and the parts list and manual will come up. Or call RJBowers tomorrow and we will email the manual. 800-383-6584

If there is no Karcher agent near you, most hardware shops and bearing outlets keep a range of o rings in stock. Take samples ot the part with you to get the correct size and thickness of o ring for your needs. Remember to put a bit of lubricant on the o ring when installing it.

if the hole is in the gun hose then no.
it will need to be replaced. try bunnings warehouse.
you may need to purchase the gun & hose together.

If you have not yet found a solution, then here are some steps to take.
1. The soap dispenser only works on low pressure!!!!!!! So you have to REMOVE the high pressure Sprayer so that all you use is the Trigger Gun without the Extender.
2. Pull out the thin Plastic Hose with the filter attached in the end, and insert into your container of detergent.
It will only splatter the detergent over the area you want to clean, so you will then need to REATTACH the SPRAYER into the hand gun to work with the soap to lather, clean and spray of till clean.
This seems to be the way the system works on this model......also known as K2.36M (AU) in Australia or (EU) in Europe on the Karcher.com.au site then Service then Manuals. or on the link below.
Hope this helps any of you who has misplaced their Owners Manual just like I did and had a great problem trying to find a link as Karcher doesn't recognize the Model No: as Winner 10 or 11.

Cheers, Luke

DO NOT USE HOT WATER!!! This machine is rated for cold water, the pump head is made out of plastic, the plastic pump and electric motor are cooled by the cold water that moves through the pump. If you add hot water into the mix there is a good chance that you are going to overheat the unit.

Just using cold water on the grease trap might do the trick, try using a good quality degreaser, I would recommend a product called 8-Ball, this is a great degreaser and should help to solve your problem.

Hi, I had the same problem, Replaced the O rings and the rubber seals and cups inside the pressure washer and eventually the hose itself burst. Turns out the hose was leaking, internally between the inner sheath and the outside plastic cover, for quite some time and this caused the pulse. New hose and pressure cleaner is as good as new.