Question about PSI Electric Pressure Washer
...gun also a Karcher part? If all are Karcher parts, they should fit unless the screw threads have been damaged. If they are not all Karcher parts, they will not fit because Karcher connectors are ...
where does small spring fit in gun of karcher pressure washer kb4040 Most Karcher guns I have worked on have had a spring behind valve between hose pipe inside gun.
...karcher gun, I never had the lock problem again and whenh my neighbor's KArcher worked with my gun his Karcher locked up after a while. Replaced the gun for $30 and works like a charm ...
...gun I just install a new hose for my Karcher 330?Hose is working, but the trigger gun is lose, no turn off went is released, the equipment is always on ?..did I missing a part inside the gun ?.. It ...
Question about K2.26 Electric Power Washer
Karcher K2.900M spray gun leaks. Not sure which replacement gun to get or if there is anyway to fix it. Thanks www.pressure-washer-parts.com has many parts available. There are complete guns, and gun ...
Question about FactoryReconditioned K240R 1400 PSI 13 GPM Electric Pressure Was
Karcher Model K 2.40, water is leaking from the gun at yellow trigger. You are going to have to purchase a new trigger gun, they don't offer any parts for replacement on the inside of this trigger gun
...Karcher K2.35 keep blowing the gun hose off? There is a good chance you are missing the black plastic clip that holds the hose into the trigger gun. If you look at where the hose goes into the gun ...
...from the trigger you may need a new trigger gun. If you tell me your model number (1.xxx-xxx.0) i can tell you the part number that you will need to give to your Karcher dealer/supplier to replace
karcher gun leaking The gun on my Karcher 520M leaks but only when the trigger is pressed, even after I replaced the o ring (PINK IN COLOUR!) on the metal part of the hose that enters the gun. I have ...
Question about 2500 PSI Pressure Washer
gun off handle on karcher B202 Hot water, not boiling, pour over the joint and then try. I take it the joint is the standard push in type. When re-fitting, a smear of grease around the joint would not
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions