Washing machine keeps stoppping.

check for a a broken bracket

This machine will beep and stop washing when the load is out of balance. Have you tried removing the clothes and lying them in again (carefully) and pressing the START/PAUSE button to complete the wash?

Hi Gina,
When your machine stops during the cycle does it beep & hold some of the wash progress lights on?
This is how it displays where the fault is coming from.
The motor controller is the most common for this type of fault.
Thanks
Damien

check that the water flow solenoid is operational and not blocking of the spray rinse requriement

Your Aquasmart machine requires 4 new suspension damper rods & 4 top bands, these are a common problem for AquaSmart machines.

Check the washer drain hose for clogs.

I had the same problem before, but removing the kink in drain hose does the trick. Maybe yours is more complicated but try it.

May be a problem with agitator gear box,open on wash cycle and use screwdriver to by pass cut off switch by pushing screwdriver down on little switch that is located where tab on lid is.If agitator is traveling at too much of a rotation that may be cause,also agitator mat be lose if you can grab and move up and down.Then remove cap on top of agitator and tighten bolt,if lose if not agitator may need to be replaced!

Maybe the machine is telling you that your load is uneven, When going through a spin cycle it will detect if the load is too heavy on one side. Just open the door and spread the load evenly. good luck.

See if you are overfilling you machine or the load is out of balance. Even try running the machine empty