Maytag refrigerators mtbe1956de liquids have dripped on to the bottom glass shelf and seeped under the edges where it cannot be cleaned. do I have to remove the vegetable drawers and totally dismantle the bottom shelf to remove the galss to clean this up?

I seem to be having the same issue with a Maytag refrigerator model M1TXEGMYS01. I would like to thoroughly clean all shelves of this new-to-is refrigerator but I can’t seem to figure out how to remove the glass from the plastic housing. I was able to take the end and central brackets off (that hold the drawers) but I can’t figure the rest of it out... and the manual I looked up didn’t provide any information on separating the housing either. Please see pic attached. Thanks in advance!

if the glass has plastict trim like pieces across the front and rear edges try pushing up on the glass close to the plastic trimat th rear end, the trim should swivel up and the glass pop out of the groove

Will they go in the dishwasher? If not, use an old toothbrush to get into the edges; use lemon juice or vinegar to degrease, rather than a bleach.

Unplug the refrigerator from the power source and remove the decorative vent cover at the bottom of the fridge under the door. Some vent covers are screwed on but many just snap onto clip that hold them in place.

Pull gently on the exposed front edge of the drip pan and ease it out towards you. The drip pan slides on runners on each side of the bottom of the refrigerator. It may be full of liquid or debris so go slow and steady and then discard it.

Line up the new drip pan with the two side guides beneath the refrigerator and slide into place. Use the flashlight if to make sure the drip pan is in the groove on each side.

Clean and replace the vent cover by clipping or screwing it into place. Plug the refrigerator back into the power outlet

You didn't mention what the brand is. This is important for accurate troubleshooting.

it must be removable , if it break one day it have to be replace so try harder it must come out somehow

240350614 is the part number for the shelf border that you need...price is around $26

Hi, The screws in the bottom edge of the door will need to be removed. The dor handles screws usually help hold the upper part of the door together. There might be screws on each side. Makes sure the door is laying on a flat surface and be gentle with the glass pieces. They are very fragile.
I am sending you a picture of the door pieces and how they line up inside the frame.
Please let me know if I can assist you further.

Vic

Hi, The door has anywhere from 2 to 4 glass pains. Some models ranges you can just lift the door up and remove it from hinges. There are screws holding seceral layers of frame work. The outer shell should remove first with screws on the bottom edge of the door. With any luck, that is all you will need to remove.
I hope this helps you.
Please provide model # and let me know if I can assist you further.

Vic

lift the front nosing by prying with your fingernails up...it will roll in place allowing you to remove the glass