Maytag Refrigerators - Recent Questions, Troubleshooting & Support


Hi! Please check the manual. There should be info or a contact of their customer support. https://manualsbrain.com/en/manuals/1401540/?page=17

Maytag... | Answered on Feb 28, 2019


Give it about an hour. May have gone into defrost mode.

Maytag... | Answered on Feb 11, 2019


Program code is located on the serial plate

Press and hold the Door Alarm keypad.

Press and hold the Freezer Temperature Down keypad within 3 seconds.

Release the door alarm keypad and wait 3 seconds.

The control will display PE to indicate the programming mode.

Press the Freezer Temperature Down once more.

The control will display the current Program Code. This should be the same as the program code on the serial plate. If the code is correct, press the Door Alarm keypad for three seconds to exit.

Press the Refrigerator Temperature Up keypad or Refrigerator Temperature down keypad to change the digit value. The decimal point indicates the selected digit. Press the Freezer Temperature Up keypad to select the next digit. Once the correct program has been entered, press and hold the Freezer Temperature Down keypad until the program code begins flashing indicating it’s been saved. Exit the programming mode by pressing any key.

Maytag... | Answered on Jan 16, 2019


THINK THEY JUST LIFT OFF THE SIDE AND NEED UNPLUGGED . WITH WATER TURNED OFF FIRST

Maytag... | Answered on Jan 10, 2019


Pull fridge out and make sure everything isn’t covered in dust.

Maytag... | Answered on Jan 07, 2019


WITHOUT BEING ABLE TO TEST IT CAN ONLY THINK IT MIGHT NEED FREON AND ONLY SERVICE PEOPLE CAN DO IT FOR US

Maytag... | Answered on Jan 07, 2019


Did you Press and Hold the "Filter" button for 5 seconds?

Maytag... | Answered on Jan 07, 2019


First try removing as described by your manual (See below).

The glass may be stuck in the track. Small amounts of liquid may "glue" the glass to track.warm up the compartment by shutting power off and leaving door open. Use a round ended thin spreading knife. Wet it with warm water and try to slide it between the glass and the track. Work it along the crack until they separate with a gentle wiggle.

From the owners manual
Important information to know about glass shelves and covers: Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. Tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use both hands when removing them to avoid dropping.

Refrigerator Shelves The shelves in your refrigerator are adjustable to match your individual storage needs. Glass Shelves To remove a shelf: 1. Remove items from the shelf. 2. Slide the shelf straight out to the stop. 3. Depending on your model, lift the back or front of the shelf past the stop. Pull the shelf out the rest of the way. To replace a shelf: 1. Slide the back of the shelf into the track in the wall of the cabinet. 2. Guide the front of the shelf into the shelf track. Be sure to slide the shelf in all the way.

Maytag... | Answered on Jan 06, 2019


Never seen one that wasn’t easy to get out unless it frozen in place. If so, thaw it out.

Maytag... | Answered on Dec 25, 2018


This site shows the small tabs on the lense https://www.repairclinic.com/PartDetail/Large-Part-Image?imgID=1003776&locID=3336
A small screwdriver gently pull back in the opposite of the tab. Try with just fingers first as ofthe lense is too cold the tabs can snap off.

Maytag... | Answered on Dec 22, 2018

Not finding what you are looking for?
Maytag Logo

7,952 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Refrigerators Experts

Bailey's...
Bailey's...

Level 2 Expert

222 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

Carlos Alvarez

Level 1 Expert

16 Answers

Are you a Maytag Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...