Ar-160 display says "check panel" no more codes or functionality

Could be an error code, is there a number preceded by an sc displayed on the panel?

Hi, whoever administrates that copier has set it up for key counter management, which means that unless you supply the correct key (which is typically a card that you swipe or a code you enter) you can't make color copies. If this is your copier, you can disable key counter management:
- Press the User Tools/Counter button. - Go to System Settings. - Go to Admin Tools. - Find the option for Key Counter Management and turn it off. - Exit out of User Tools.
Now you should be able to make copies normally.

Hi, somehow the external key counter option for your copier got turned on. This option is typically used for coin-operated copiers such as those found in libraries. You can turn this option off by doing the following:

- Press the User Tools button - Select System Settings - Select Admin Tools - Select Key Counter Management - Choose Off, or de-select the full-color option if it is selected. - Exit out of User Tools

Now you should be able to copy normally!

HI

Got this from usa canon.com website click here and type error code in the search box
a list of the error codes will be displayed and you can then click on the relevant one.

"Issue: ERROR LCD: Error Code 5010
Solution: Press ON/OFF switch to reset the multifunction device

Reset the device when it is not functioning properly.
If the device is not functioning properly or to clear memory, reset it.

1. On the operator panel, press and hold the <ON/OFF> button for one second. (The display will go blank.)

Note: It may be necessary to unplug the power cord if pressing the ON/OFF button does not shut off the printer.

2. Wait approximately ten seconds and then press the <ON/OFF> button again.

3. Wait until the device has completed its cycling process before submitting another job request."

Hello sir; The error code you have display, its means the fuser oil waste bottle full, check it out and dump it out, otherwise that's senser problem.

Hello sir; A-1 code means discharge corona cleaner problem, check it up may be the cleaner not function right.

Issue: ERROR LCD: Error code (5xxx through 9xxx) appears on the display
Solution: Press ON/OFF switch to reset the multifunction device

Reset the device when it is not functioning properly. If the device is not functioning properly or to clear memory, reset it.

1. On the operator panel, press and hold the <ON/OFF> button for one second. (The display will go blank.)
   
   
2. Wait approximately ten seconds and then press the <ON/OFF> button again.
   
   
3. Wait until the device has completed its cycling process before submitting another job request

Performing a Fault Reset 14 will reset your WorkCentre and will help to clear error codes.

1. Find the pink Clear button on the Control Panel of the WorkCentre.
2. Find the button below the word Auto.
3. Press these buttons in the following sequence: [Clear], [Auto], [Clear], [Auto] NOTE: All of the lights on the Control Panel should go out and the LED Display should go blank. If the lights do not go out, then repeat step 3 until they do. It may be necessary to increase or decrease the pace of the [Clear], [Auto], [Clear], [Auto] sequence.
   
4. Press the [10's] key one time and the [1's] key four times to enter '14' in the LED Display, as if you were to make 14 copies.
5. Press the green [Start] button.
6. Press the pink [Clear] button two times.
7. The WorkCentre should now warm up and come to ready.
8. If the above steps do not clear the error code, repeat steps 3 to 6 a second time.

plese write the error codes coming on the display