Sony vpl hw 50se hd ports damaged due to static .which part needs to be replaced & where can I get the part

you must change the lens. the cost is high. see the sony site for replace the parts.
Sergio

it could be due to an incompatible lamp which has blown once again or it could be due to a faulty ballast
open the lamp and see if all looks good!
if lamp looks ok, u need to check the ballast,
before that just do a quick check on the small switches which are under the filter cover.
if the cover locks have got damaged then the switches will not close and hence show a similar problem.
this is the most common problem with SONY projectors

Hi,
Here i have added the link to the manual of Your projector. Downlaod the manual and reffer page no 55 to 58 Which discribe how to repalace the air filter. You can clean the air filter and refix the same. If you need to replace the air filter with a new one the you have to contact sony authorised servicing centre for new one. If you need any more assistance feel free to contact me on [email protected]

Usre manual
Ajin

There is a small switch that detects when the lamp cover is securely tightened down, so that it protects the user from the high voltages, hot surfaces, excessive bright light in the eyes, and damage to the face if the lamp implodes due to old age and overuse.
so check if the switch operates when a toothpick is pushed up and down in the cavity.This model suffers this problem when the cover is slightly warped with old age.
so put a strip of folded paper between the cover plastic protusion that actuates the switch and the switch and secure the cover and see if this is all that is needed to activate the switch properly.

if it now works, you can try putting a small drop of silastic on the cover protusion and wait till it sets over several hours in order to lengthen it slightly so that it reaches the switch properly

Sears should have it.
Here's a link to their site for your device.
Exploded views and part numbers
http://www.searspartsdirect.com/partsdirect/part-model/Sony-Parts/Projector-Parts/Model-VPL-AW15/0996/0534000?pathTaken=&prst=0&shdMod=VPL-AW15

reset the settings to factory default and change your cable. if that doesn't help, the polarizer filter on the blue lcd panel is fried due to excessive dust and heat. the optical engine will need to be replaced.

one of the light filters on the lcd panels has a burn mark on it. probably the green. it is due to dust in the optical engine. it needs cleaning and the light filter needs replacing. unfortunately, most projector companies don't sell or repair individual parts, and you may need to replace the whole optical engine (which is pretty pricey).

1080i should need HDMI Or DVI port and check ur manual as ur projector native Resaluton is 1920*1080 !!!

Hi there

Replacing the lamp won't make any difference at all.

If you have checked the fuse on the Powersupply Board and it tested ok , then the whole Board will need replacement.