Gas Dryer blowing cool air and will not heat up.

If the igniter glows but it doesn't ignite, most of the time, it's the valve coils, most of the other times, it's the radiant sensor.

If the igniter doesn't glow, check your thermal fuse. If your thermal fuse is good, replace your igniter.

Good luck!

Good Afternoon Friend, thank you for your question!

I understand you are seeking a replacement dryer belt for your Frigidaire laundry center, GLET1031FS. The replacement dryer belt part number that you would need to order is 137292700.Most parts can be purchased directly from the manufacturer or through a parts distributor in your area (part numbers may vary based on distributor). Hope this helps! - Z

Simple. Your solenoids are overheating because of age. Most American dryers use the same 2 coils:




This video of mine shows how to replace them:





If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The flame sensor, ignitor, and coils all are wired together in a complicated circuit so that the coils will not operate untill the ignitor is out of the circuit and is screaming hot. If the ignitor is open or bad the coils will not operate because the ignitor becomes like a thermocouple when screaming hot. So if the ignitor is working and the flame sensor is working properly AND the dryer will work some and then quit, I would suggest to you that the coils are aged and when they get aged they tend to fade and die when used once or twice. It is an aggravating thing to diagnose. Replace the solenoid coils and rock on dude!

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

This is most likely a bad ignitor(can be verified by inspecting burner and ignitor with the machine running. But I would also check the vent pipes from the dryer all the way to the outside to make sure there isn't any blockages or restrictions. I would need a model number to provide more specific details.

You may have aproblem withthe venting. Make sure the the fan can blow freely through and out the vent. If this gets parially blocked it cuts down the air flow and will make the dryer run too hot and keep the burner off. The other thing taht it could be is the temperature sensor that turns the gas burner on and off. Sometimes they will go bad and not let the burner stay on long enough to heat properly.

Need a model number to find a wiring diagram.

my washer make a loud sound when spinning

The identification label from a Frigidaire Gallery Commercial Heavy Duty Moisture Sensor drier has come off. I need to download operating/user manual. How can I get the serial no. or model no. The drier is 4 years old.

Failed heating element.