E11 code on electrolux dishwasher - Electrolux Dishwashers

Try turning off the power and the lock should release.

What does e11 mean on Electrolux washer? - AskingLot.com

https://askinglot.com > what-does-e11-mean-on-electrol...
Mar. 26, 2021 - This E11 error means that the washer didn't fill up with water ... the display simultaneously for 3 seconds to enter the diagnostic mode.


..

E11
NTC thermistor fault.
This error code can be caused by the thermistor or the wiring to it being faulty.

Dado

It is the customer fault code. Simply turn on and turn off appliance.
E11 - problem with fill water
E21 - problem with draining water
E41 - door open
All other errors require service staff !!!

Hello friend, thanks for your post!
I see that your Electrolux washer is giving off an "E11" error code. An "E11" stands for water is not entering, which can be several possibilities. The water supply to your home has been interrupted or water pressure may be low. Check the hoses to assure they are not kinked and the drain pipe is proper per installation. If these steps have not resolved your issue it could be a problem within the control panel and I would perform a reset on your appliance, which is disconnecting power from it for roughly ten minutes. Hopefully this helps. -Matt

Good Afternoon Friend, thank you for your post!

If you are receiving an error code E11 on your Electrolux dishwasher (EDW7505HPS0A), it usually means that you are experiencing a problem with the drain valve. If you have already replaced the vale and pump, at this point, I would recommend reaching out to a professional or alternatively, visit the manufacturer website for a comprehensive listing of appliance techs in your area that can ensure the wiring between the main control and the drain valve was correctly installed. Best regards! - Z

Hello Paul, thank you for allowing me to assist you!

If you are receiving an error code E11, your dishwasher has detected an issue with the main control board timing out before receiving status of the drain valve. A qualified technician would pinpoint the problem by checking the wiring between both parts. If the wiring isn't the issue, he would need to determine whether the problem rest with the main control and valve. It really could be a hit or miss calculation in parts so I would personally reach out to an experienced tech that will be able to identify the precise reason.

Best regards!

E11 indicates a communication error where a technician needs to diagnose the control board.