20 Most Recent
Avaya Corded Phone avaparp18d - Page 7 Questions & Answers
HOW TO SET CLOCK ON PARTNER 18-D
Changing the time on a Partner system is done on either ext 10 or 11. At one of those ext's press the feature key and "00"
next press the left hand intercom twice
the display should say system programming
enter in "#103"
the display should say system time and the current programmed time
enter the new time in 24 hour format
press feature "00" to logout
Where is the battery that needs to be replaced
In an ACS system, it's on the processor card. The bottom part of the face of that card has a plastic guard (usually black) that slides back and a tab that you pull out and the batteries fit in the holder.
Do this with power on. It takes 2 AA alkaline batteries.
Carl
When zero is pressed after listening to the night
hello,it is your setting that is malfunctioning,so all you need to do is just to reset the avaya system,you can run the reset if you visit your manual,after that is done you will have your avaya system working as normal.
take care.
Avaya Partner line always lit
If the line button is lit then something within the system has picked it up. If the phone is a multiline set, the line 1 light on the set that is using the line will show green. The line could also be held by either a cordless phone on the system or the voicemail system. The easiest way to clear the line (if the held set isn't apparent) would be to cycle down the power to the phone system for a moment. That will clear the line if its held by the voicemail
How to restore manufacture setting on 18D Avaya
It's not that simple. You can clear all the non line buttons from a set by pressing FEATURE 00 , the button and MIC/HFAI. Line selection and line appearance is programmed from Centralized programming on the main phone(s). You can also use COPY commands to make a phone behave like another.
Carl
Hola tengo una centralita Partner acs
To program a flash key press feature 00. then press the key you want to be a flash button, then press feature 03. Press feature 00 again to exit programming.
When I am on a call, how do I answer the call that
You can either press feature 03 (recall) while on the telephone callto switch between the callers or you can program a recall button on your phone by pressing feature 00, press the button you want to make your recall button. and press feature 03.
Not finding what you are looking for?