20 Most Recent
Maytag MAH6700AWW Neptune Front-Load Washer - Page 5 Questions & Answers
SUD AND F-35 PROBLEM
SUD=
The "Sd" code indicates that you have added too much detergent to the washing machine and your laundry has too many suds. The machine will stop displaying this code if it has successfully run the suds recovery cycle, which removes the excess suds from the wash load. If the code remains, reduce the amount of detergent in the load. Use less detergent for similar loads of laundry in the future
As far as F35. Check your owners manual to see if its in there. Also if you remove the top lid ( a couple screws in back hold it in place) and check inside you will get the technician diag sheet which will have codes.
2/21/2013 9:41:33 AM •
Maytag...
•
Answered
on Feb 21, 2013
Leaking gasket
Need to replace your boot seal. If you do not what to go to that expense, if the hole is small you can use silicon sealer to patch the hole and let it set for at least 24 hours.
1/27/2013 1:19:26 AM •
Maytag...
•
Answered
on Jan 27, 2013
How can I drain my machine
Unplug & plug the machine. Then hit the Draine cycle. This has worked for us in the past.
1/12/2013 12:59:58 AM •
Maytag...
•
Answered
on Jan 12, 2013
Maytag 4000 series error code F 29(door unlock error).
Thank you Jeff Rockwell for trying to help me out.I did all the step and I replaced it with the new switch/lock that i got for Ebay but still the same problem. I diagnostics using the tech.sheet and still say F 29. Not sure the new switch/lock is bad. How can u test if the new switch/lock is bad?
12/21/2012 7:39:51 AM •
Maytag...
•
Answered
on Dec 21, 2012
NS error code
you must call to Maytag Neptune Priority One Service
(888) 462-9824God bless you
10/17/2012 4:39:12 AM •
Maytag...
•
Answered
on Oct 17, 2012
My maytag front load washer door wont open and wont start either
see this causes and fix it. God bless youFirst to unlock depending on model. There will be a pull tab either
under the lower kick panel, behind the filter cover, or under the top
panel. Pull this tab to unlock the door. Now you can remove the clothes
and water. Refer to the owners manual for the location of your emergency
door pull tab.
Door Switch
You will need to
remove the door switch
to check it. You will perform an ohm reading on the bottom terminals.
The reading varies from manufacturers most Frigidaires is around 1500
ohms others like the whirlpool duet is checked at the main control board
with the door closed should be around zero ohms. You will need to refer
to the tech sheet or service manual for the proper reading.
Main Control Module / CCU
The main control unit is the circuit board located behind the console.
If the door switch tests good the main control is usually the problem.
Check all connections for a goood tight fit. You will need to refer to
the tech sheet or service manual to check this further. The
main control is easy to replace.
http://www.appliancehelponline.com/washercontrolboard.html
10/15/2012 6:00:55 PM •
Maytag...
•
Answered
on Oct 15, 2012
Not finding what you are looking for?