20 Most Recent
Fisher and Paykel Aquasmart wl80t65c - Page 10 Questions & Answers
Fisher and paykel GW612 fault code 11110000
RPS (Rotor position sender) fault. The RPS is an electronic sender unit mounted on top of the motor winding. It tells the main control board what position motor is at for it to start properly and also if motor is actually running. Replace the RPS.
Our fisher and paykel washsmart goes halfway through its cycle then peeps continuously and on the display panel shows 40 who how can I fix this faultd
Error code 40
40. (00101000) Inner Basket Disengage Fault
While carrying out a basket check, the Motor Control Module has found that the basket is
not engaged even though the pressure sensor indicates that the tub is empty. The Motor
Control Module continues to check for 2 minutes, after which time it displays this fault. The
first two areas to check are the clutch and the pressure tube. If these two appear correct,
then the fault could be in the pressure sensor in the Motor Control Module.
Primary Source: Mechanical.
Action: 1) Check that there are no clothes or other foreign objects preventing
the clutch from re-engaging. Excessive suds can stop the basket
rotating.
2) If the machine is empty of water, carry out a clutch disassembly
procedure (Refer to section8.14) and check the spline drive.
3) Next check that the pressure tube has not come off and that it is
not kinked.
Secondary Source: Motor Control Module.
Action: Replace Motor Control Module.
8.14 Removal of Clutch Mechanism (Spline Drive / Spline
Driven)
(a) Follow the procedure for removal of Inner
Basket. (Refer to Section 8.13).
(b) Remove the 3 screws securing the spline
driven to the inner basket.
Reassembly:
Refit in the reverse manner. Ensure that the
screws are tightened sufficiently with out over
tightening.
Not finding what you are looking for?