Fisher and Paykel Aquasmart wl80t65c - Answered Questions & Fixed issues

remove bowl and clean them both

most likely a faulty lid lock unit

if its a top loader that is incorrect it mean machine needs resizing and if tht doesnt work a new main control module

most common problem is worn out suspension rods will need new set fitted

restricted pump or drain hose if all good them probably a faulty pump

this is all one unit hot and cold together sealed unit

put powder down inside agitator not do not sprinkle over clothes not remove top off agitator first

Fault code 49 is water valves - usually, the stop working when the rubber diaphagm inside gets hard, so a resistance only test is not conclusive (only tells us the solenoid is OK). - Do a cold fill and a hot fill (briefly) to check for strong water flow on both. - Regarding code 245, does water pump out strongly? - One more thought, because these codes are both related to the water level in the machine, remove the level sensor hose at the controller end and blow into it to clear any blockage.

Yes the shop you bought it from. At only 12 months old the warranty should still apply.

check for faulty pump

Replace just the lid lock assembly to start with and see how it goes. Lids are quite expensive and don't usually need replacing. You can always get a lid later if you still have problems.

Hi there..... mine did the same a couple of months ago, kept towels around, monitored, seemed to stop after some days (uses); Any update on yours ? Self-healed, Repairman, or Replaced ?

Switch to Powdered Detergent and you wont have to clean your washer. Liquids leave a smelly, corrosive residue on the inside of the machine, use only Powder and leave the lid up when not in use to defeat the slime!

Inside the drain pump. You can get to it by removing the spin bowl. Remove the 2 screws holding the pump cover & lift the cover off to expose the flapper valve.

its overloaded

javascript:;To size set a L.C.D AquaSmart™ machine: 1. Press and hold the left SCROLL button, then press the HIGH EFFICIENCY button until two beeps are heard. 2. Press the SCROLL button to select the machine size (600 for WL70, 650 for WL80). 3. Press the POWER button

these are a common problem for AquaSmart machines. Your AquaSmart machine requires 4 new suspension damper rods & 4 top bands,

Your AquaSmart machine requires 4 new suspension damper rods & 4 top bands, these are a common problem for AquaSmart machines.

Have you run a "Clean Up" cycle - it is important to do this to ensure your clothes are clean and the machine works at it's peak. If you use it heavily, you should do this every three or four months. You can find this cycle under "Lifestyle" and you should put 1 cup of oxyaction soaker in at the beginning of the cycle and it needs hot water to work. It takes about 3 hours, but is well worth the time. There is no other real reason for a smell, unless something has died - in which case you should move the machine and remove any deceased animal.

Hi! Have you completed a "Clean Up" cycle? It should prompt you every 100 washes to do a clean up - it should be under the "Lifestyle" menu. When you do it, I suggest you use OXY soaker (1 whole Cup) instead of normal detergent and make sure it is all HOT water. It soaks for 4 hours, but is very good at cleaning the bowl and workings to stop brown marks on your clothes and towels