20 Most Recent
Jensen VM9510 Car DVD Player - Page 4 Questions & Answers
Keeps ejectin my cd
Jensen radios are notoriously unreliable (which is why they've gone out of business several times. New companies buy the rights to the name and release inferior products under it).
Unfortunately, since Jensen is no longer a legitimate company, parts are not available and, thusly, repair is not possible.
My radio will play perfectly
try using your blue/white wire instead of the blue wire to turn your amp on. The blue wire is power antenna remote turn on and shuts off when leaving tuner mode. The blue/white wire is amplifier remote turn on.
My jensen uv8 display will
It sounds like the flexible cable between the monitor and main motherboard might be bad. You might be able to get a new one from audiovox at audiovox.com.
How do you set a radio station to a place?
I would assume that this Jensen should store stations much like other cars. Find the radio station you want, press and Hold the button in until you hear the radio start again. Note- If you installed the radio your self and didn't hook up the power correct, the programed radio stations will be lost when the vehicle is shut off! Hope this helps!
Best Wishes and Good Luck!
I wired up the radio and it turns on then right
It sounds like your auxiliary and constant power wires are switched around. Switch your red and yellow wires around. You could also have a bad ground. Did you use an aftermarket wire harness to connect to your factory wire harness, or did you "hard wire" them?
Is says parking when I'm trying to watch a movie
HELLO YOUR ISSUE IS THAT THE STEREO'S PARKING WIRE IS NOT PROPERLY CONNECTED. YOU NEED TO CHECK THE WIRES ON THE BACK OF THE STEREO AND LOCATE THE PARKING WIRE USUALLY SOLID GREEN WIRE AND CONNECTED TO A GROUND WIRE OR DIRECTLY TO YOUR CHASSIS TO GROUND IT.
Need the parking bypass code for jensen vm9510
1: Go into AM/FM mode
2: Hit "setup" on the remote control
3: Enter 543210 on the remote, listening for the beep for each number entered
4: A new menu will appear. Touch the button that has the hammer/screwdriver on it in the upper left-hand part of the screen.
5: Select Brake bypass to "ON" and hit the "X" near the bottom of the screen
6. I am not responsible for whatever you do with this code!!!
Dvd player not working says error but will play
dvd player will only play movies for the COUNTRY in which you purchased it. There is no way to purchase a system or configure a system to play ALL MEDIA FOR ALL COUNTRIES. The country codes are specific and each country wants to prevent any other country from playing their dvds music, etc.
Not finding what you are looking for?