20 Most Recent
Jensen VM9510 Car DVD Player - Page 3 Questions & Answers
I have a jensen uv10 and how do i connect my
You actually have to purchase the bluetooth module seperate, its just a box that clips to you're visor and has a microphone and a connect button on it. It has one cable which is ran to the back of your stereo. The one made for the uv10 is called the btm10. However I have found that the btm15 works much better and has 2 microphones in it (one for calling and one for voice searching). You can find these on amazon and also jensen.com the price range runs from $40.00-$80.00......... Hope this helps you out...
How do I watch videos in drive in 1996 cadillac deville
Nice car. I have a 96 Deville also and i'm installing the same radio in it in about 2 days. there are two options to bypassing the video lockout:you can either buy the PAC TR-7 bypass cable which costs around 20 bucks on sonicelectronix.com or you can wire the parking break wire to a toggle switch and ground a wire from the neg end of the toggle switch.The PAC controller is way more convenient because you dont have to flip the toggle switch 3 times everytime you get in the car.I hope this helped
Where can i buy the flex ribbon for my jenson
Hi,You can find it here :www.ebay.com/sch/sis.html?_nkw=Screen+Protector+Jensen+VM9512+VM9312+VM9510+VM9412( If link fail, copy and paste above adress on your search engine bar)regards
Says parking when I try to play dvds
You might not be in PARK. Or the relay is not hooked up to the parking switch.As a safty function Indash DVD players will only play if they know the car is in park.But it can be bypassed to work while in drive.Selvol
Jensen VM9314 remote does not work...not the
Your remote may be faulty.I would either take it to an autozone and check it is working there ( they have an infrared remote check on their keyless remote battery center that will show the IR signal being sent).ORyou can point it at almost any of the security cameras in production and view the 'IR flashlight' on the video screen/ monitor.If the remote is in fact not producing a light , I will assume the unit needs replacement batterys or remote.Alternately , you can disassemble the remote and check the IR emitter with an Ohm/Volt meter.should the signal be present on the meter and yet no 'light' is being emitted , then replace the emitter with a new one (avail. at radio shack...)If the remote does emit a signal , chances are the reciever is bad.My Jensen came with two remotes... did you try the other one ?
Phase Linear UV8
go to setup hit 543210 but hold 0 then turn the bake override on and then hit the X
Phase Linear UV8
I have same problem with same uv8 but i use remote to activate am/fm then hit setup on rem.enter 543210 and a new menu came up. ( listening for the beep after each 3 is pressed ) select the hammer in upper left hand corner of screen, select brake bypass to on, then hot the X near bottom os screen. this works for me it should work for you.
Not finding what you are looking for?