American Standard 2002.014 - Champion4 Right Height Elongated Toilet Combination - Two-Piece - Page 3 - Answered Questions & Fixed issues
My husband in stalled in shower vavle body. When bathtub is filling, water comes out shower head any ideas.
It's possible you installed the valve upside down, all values should be labeled in some way marking either hot and cold or it will say the word up where the riser tube port for the shower head is. If that's not the case remove the tub spout and check for any obstruction sometimes during tile or constructing debris can get into the pipe for your tub spout. Lastly the diverter on the tub spout could be bad. Try a new tub spout
3/6/2016 5:12:46 PM •
American...
•
Answered
on Mar 06, 2016
•
355 views
How to fix a leaky toilet
-
Turn off the water at the shutoff valve, flush the toilet and hold down the handle. There may be a little water left in the bottom of the tank, but don't worry about it. Wipe the flapper seat with a clean cloth to make sure it's free of debris, and check it for cracks or splits (Image 1).
www.diynetwork.com/how-to/.../how-to-fix-a-leaking-toilet
DIY Network
Feedback
www.thisoldhouse.com > ... > Toilets
This Old HouseA toilet that leaks or runs is an easy homeowner fix-if you know how to diagnose the trouble. ID parts and problems with this handy guide, and hit the hardware ...
12/27/2015 12:39:00 AM •
American...
•
Answered
on Dec 27, 2015
•
798 views
Leaking toilet tank
Is the tank cracked or is it leaking from the bolts that go through the bottom? If the bolts are leaking shut the water off, Should have a shut off valve behind the toilet, If not possible around your house. Mine is out by the road where the water meter guy can check it. But shut the water off and put 2 new bolts and gaskets through the toilet. Very cheap fix. under $4.00 USD
3/10/2015 9:26:49 PM •
American...
•
Answered
on Mar 10, 2015
•
880 views
Repair crack in floor of acrylic shower
Hello their is a product called Plasweld,it comes in a handy tube,
Carefully scratch along the crack to allow the weld to come flush with the surface of the shower tray,MUST BE PERFECTLY DRY!
squeeze into the crack and it will find its own level ,this produce actually welds the plastic together
Good builders merchants should stock this item.GOOD LUCK
9/15/2014 12:00:54 PM •
American...
•
Answered
on Sep 15, 2014
•
131 views
Overflow tube
If you manually pull up on the float of the fill valve will it then shut off? If it does, most likely your water pressure is too high, should be around 60 psi. More then 80 and it won't shut off. You may need to add a restrictor to the fill valve. Most fluid-master units come with one already installed, you could try one of them.
8/23/2014 7:52:21 PM •
American...
•
Answered
on Aug 23, 2014
•
152 views
Not finding what you are looking for?