...shaft. REMOVAL Remove the oil pan. Remove the oil pump from the rear main bearing cap. Remove the vibration damper. Remove the timing chain cover. Identify bearing caps before removal. Remove bearing ...
Question about Dodge Dakota
...The drive shaft comes out, the seal comes out, and the install is reverse.You can check the cost of the part online for your area and whatever the labor rate is for your area, I would say 1 - 2
Question about Dodge Dakota
...shaft came out of transfer case I believe bearing and seal smoked up We don't have that infoTry a local trans repair shopThey usually install a salvage yard unit,so be careful what you ask for ...
...shaft , udo large nut with impact and then yoke with puller , then seal is removed and new seal installed and reverse rest of procedure labor time is about 1hr and part about 20.00 save yourself a ...
...shaft seals do develop leaks, the best thing to do is just install a rebuilt unit, install a good quality rebuilt steering unit either from the dealer or from a company called A1Cardone. Trying to ...
...shaft with slot in the distributor oil pump drive gear. Install the distributor hold down clamp and screw and tighten finger tight. Install distributor cap and wires, making sure all high tension ...
...a single assembly with the wheel hubs and they should be replaced as a single unit. Fortunately, installing a new assembly is not a difficult process. Removing the Hub/Bearing Assembly Before ...
...shaft and No.1 piston position as follows: Rotate crankshaft until number one piston is at top of compression stroke. Mark on crankshaft vibration damper should be in line with "0" TDC mark on timing ...
22833. Install the deflector (28). Install the axle shaft (output shaft) (19). Carefully tap the axle shaft (output shaft) (19) into place with a soft mallet. Install the differential carrier assembly
Question about Dodge Dakota
...Install axle shaft through seal, bearing and engage into side gear splines. Install C-lock in axle shaft end, then push axle shaft outward to seat C-lock in side gear. Install pinion mate shaft into ...
584 questions posted
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions