1991 Dodge Dakota "40 amp blowing fuse ignition" Questions

...40 amp when I check the voltage it is drawing 51.0 amps why when I turn the key to acc or even try to start it it blows the ignition fuse Since most of the circuits are handled by the key switch, ...

...40 amp ignition fuse fried in my 1991 Dodge Dakota. I replaced the fuse, the starter motor and the coil. The fuse fried again. What other things need to be replaced so that my engine can start? Pull ...

1991 dakota 2.5L, 4 cyclinder blows the 40 amp ignition switch fuse dead short in a wire , ignition switch or ECM

40 amp ignition fuse keeps blowing car wont start, 40 amp ignition fuse blows when i turn yhe key on U have a positive wire making ground I had the same problem. After taking someone's online advice ...

...40 amp fuse as soon as I turn on ignition The car ran fine on a long trip, then all of a sudden the engine died. The motor turns over but will not start. The shop says it blows a 40 amp fuse every ...

...and battery now my ignition A fuse blows every time i go to turn the ignition 40 amp fuse wth? Please replace the fuse with a higher rated fuse like 50 to 100 amp. Take care. Please rate this

40 amp ignition fuse keeps blowing ok. fuse to WHAT ? 40 maxi fuse takes a lot to blow.

...40 amp fuse? Wow! that's a dead short somewhere on a large wire. Could be difficult, or hopefully easy to find. There's always the smoke test option: Solder a jumper wire across the top of the fuse, ...

40 amp ignition fuse blew. I replaced the fuse and now the lights all go on when the key is turned on but the vehicle will not start...or even try to start. The battery is fully charged. The 40 amp ...

40 amp ignition fuse keeps blowing on my 1998 Chevy ST 2WD You have a short to ground on that circuit , find a wiring diagram an see what all is on that fuse . So far I see the ignition switch an ...