...fuser heater lamp wire The temperature does not reach 100°C/ 212°F after the fuser heater lamp has been turned on continuously for 30 s. 30/31 ppm printer (EUR/USA model): The temperature does not ...
Question about Canon Office Equipment & Supplies
...fuser heater lamp wire The temperature does not reach 100°C/212°F after the fuser heater lamp has been turned on continuously for 30 s. The temperature does not rise by 1°C/1.8°F ...
...fuser heater lamp wire 30 ppm model: The temperature does not rise 1×C after the fuser heater lamp has been turned on continuously 5 s. 35/45 ppm models: The temperature does not rise 1°C ...
Fuser heater break The temperature does not reach 70 °C/ 158°F in 15 s before secondary stabilization. Temperature rise of 1°C/1.8°F does not occur in 5 s before secondary stabilization (except during
...fuser roller/film life is over. Replace with new one 2. The fuser film is torn. Replace with new one. 3. Fuser heater is burnt. Replace the heater. 4. Fuser thermal sensor is open. Replace it. ...
Question about Kyocera Office Equipment & Supplies
...Fuser heater break. Fuser thermistor 1 detected less than 40°C/104°F for 10 s during warm-up and ready in. Defective fuser heater M or S. -Replace the fuser heater M or S. Installation defectiveness ...
fuser heater wire (main) When the fuser thermistor 1 reaches primary stable temperature after a warm-up start and the fuser thermistor 2 is less than 90 ° C/194 °F. Causes Fuser unit. Main/Engine PWB.
...fuser heater lamp wire The fuser temperature does not rise after the fuser heater lamp has been turned on You need to reset it in engineers service mode setting 163 ,if problem still persists after ...
...fuser heater cable from the power supply (CN602). If there is no continuity in the heater wire, replace the fuser heater and thefuser oil coating roller. If there is no continuity in the thermostat, ...
Question about Office Equipment & Supplies
to warmup. Broken fuser heater lamp wire The fuser temperature does not rise after the fuser heater lamp has been turned on. Tttt To resolve you will need a tech to replace parts in the fuser assembly
1,267 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions
