...wand. If the flimsy plastic switch used to turn the cylinder is broken, you may need a new under carriage or just set the cylinder to wand or floor manually and use it as a one dimension cleaner. ...
...switch There may be damage to where the wand connects to the back of the vacuum cleaner - you should see two grooves on the wand and two on the spine of the vac where the wand slides into - if you ...
...wand/hose assembly from the machine, switch it on and test the suction from the top of the wand with your hand. If the suction is poor, remove the wand from the hose and test the suction from the top ...
...switch on the head fully back and forth to see if the head will run without the wand. If it runs put the wand back in place and inspect electrical connections and plug terminals when reinstalling. ...
switch. Any ideas? is it the part where the hose connects to the wand or is where the wand connects to the power head? and what side keeps falling out. it sounds to me that its either a hose or a wand
switch is located on the power nozzle on the right hand side if you're looking down on it. It will be a little red pole, simply push this pole downwards, possible using a ball point pen is the easiest
wand will not come on electrical switch will not activte on floor vacuum wand just replace the switch.
...switch on the wand controls the power head but the vacuum unit comes on whenplugged in and does not turn off. I switched the wand from another unit and the same thing occus so it is in the main unit. ...
...wand. If you cant see anything coin etc put hose back on machine & switch on there should be good suction from the flexi hose, Now with machine still switched on push alloy pipe back on if the hose ...
884 questions posted
Usually answered in minutes!
1,132 Questions
870 Questions
836 Questions
597 Questions
450 Questions