Necchi 6015 Mechanical Sewing Machine "dog feet down" Questions

...feet only hold the fabric against feed dog so themachine can use the needle to sew the fabric.if the fabric is not moving then the feed dogs have to be checkedcan you see the feed dogs in the needle ...

...down how do i get it to work feed dogs (the little feet thats under the faberic when sewing) if the feed dogs  will not go up or down, even when the lever is movedthen the machine needs to be ...

...down to sit on the feed dogs. It won't sew this way. Has that particular presser foot worked in the past? Do the other presser feet work?

If it hasn't been used before, check that it is the ...

feet under presser foot clicked down not able to get back feeder feet under presser foot clicked down not sure how to get them raised up again to start feeding fabric throught again The switch for the

...down the feet. With presser foot lever down (no feet and not foot holder on), it does not stitch the fabric. You probably do not have lever to put the feed dogs down. That's why you have a cover. To ...

the feet will not push the material thew the machine (and no the dog feet are not down) Hi, I suspect there is no pressure on the presser foot. Check that. Hope this is it. Rick

feet just go up and down not in a pulling motion I'm sorry to say that it sounds like you have a broken gear that is preventing the feed dogs from moving properly. Depending on the machine, this could

...down Am unable to locate much information about the 1630, but did find this web site



where there is an Email Discussion Boards with a 1630 category. Perhaps someone on that board can ...

feet don't. Suggestions? Are you using a very thin fabric? If so perhaps you need more pressure, try turning up the pressure wheel a notch. Normal setting is 4 so perhaps up to 5 or 6. But remember to

...down. The presser foot should always be raised before removing the fabric. Are you trying to darn or quilt something without the feed dogs activated? If so, there are special presser feet for that ...